AS/NZS 2804.1:1995

1 - AS/NZS 2804.1:1995 INSTALLATION OF SECURITY SCREEN DOORS - HINGED
4 - PREFACE
5 - CONTENTS
6 - FOREWORD
7 - 1 SCOPE
7 - 2 NEW DESIGNS AND INNOVATIONS
7 - 3 REFERENCED DOCUMENTS
7 - 4 DEFINITIONS
7 - 4.1 Doorframe
7 - 4.2 Face fitting
7 - 4.3 Grille
7 - 4.4 Head
7 - 4.5 Installer
7 - 4.6 Jamb
7 - 4.7 Jamb adaptor
7 - 4.8 Security screen door
8 - 5 SUITABILITY OF EXISTING DOORFRAME
9 - 6 MEASUREMENTS
10 - 7 DOOR DIMENSIONS AND CLEARANCES
10 - 8 FITTING OF METAL JAMBS AND HEADS
10 - 9 FITTING OF HINGES
10 - 9.1 General
10 - 9.2 Fitting to timber jambs
10 - 9.3 Fitting to metal jambs
10 - 10 FITTING OF LOCK AND STRIKER PLATE(S)
10 - 10.1 General
11 - 10.2 Fitting to timber jambs
11 - 10.3 Fitting to metal jambs
11 - 11 FACE FITTING OF SECURITY SCREEN DOORS
11 - 12 STRENGTH OF FINISHEDINSTALLATION

Sets out requirements for the installation of hinged, security screen doors as specified in AS/NZS 2803.1. It applies to doors primarily used in residential applications.

This Standard sets out requirements for the installation of hinged, security screen doors as specified in AS/NZS 2803.1. It specifies the minimum acceptable standards for the installation of security screen doors primarily used in residential dwellings.

Under Revision see DR 02284 CP First published as AS 2804-1985.Jointly revised and redesignated AS/NZS 2804.1:1995. First published as AS 2804-1985. Jointly revised and redesignated AS/NZS 2804.1:1995.