We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • AS/NZS 3003:2011

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Electrical installations - Patient areas

    Available format(s):  Hardcopy, PDF 1 User, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  23-03-2018

    Language(s): 

    Published date:  01-04-2011

    Publisher:  Standards Australia

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    Sets out requirements for new electrical installations and for alterations, additions and repairs of existing electrical installations in patient areas.

    Scope - (Show below) - (Hide below)

    This Standard sets out requirements for new electrical installations and for alterations, additions and repairs of existing electrical installations in patient areas. Areas other than patient areas are not covered by this Standard, but are covered by the relevant requirements of AS/NZS 3000.This Standard nominates specific maximum values of electromagnetic interference. This matter needs careful consideration at the design stage. In some patient areas, these values need to be measured.This Standard specifies the patient area classification for certain locations.NOTES:1 Where a patient area is not listed in this Standard, refer to AS/NZS 2500 for guidance. AS/NZS 2500 outlines the procedure for determining where cardiac-protected electrical areas are required. These decisions are made by the governing body or proprietor of the health care facility, based on the classification of the medical procedures undertaken in each area and the protection against electric shock provided in the medical electrical equipment available for these procedures. 2 Requirements for mobile trolleys supporting electrical equipment are given in AS/NZS 3551.3 Requirements for emergency lighting are given in AS/NZS 2293.1. 4 Requirements for emergency power systems in hospitals are given in AS/NZS 3009. 5 In New Zealand, mobile medical connectable installations must comply with the requirements of this Standard and NZS 6115.

    General Product Information - (Show below) - (Hide below)

    Committee HT-021
    Document Type Standard
    Publisher Standards Australia
    Status Superseded
    Superseded By
    Supersedes
    Under Revision

    History - (Show below) - (Hide below)

    First published as part of AS 3003-1976.Second edition 1985.Jointly revised and redesignated in part as AS/NZS 3003:1999.Gourth edition 2003.Fifth edition 2011. Originated in Australia as part of AS 3003 1976. Originated in New Zealand as AS/NZS 3003:1999. Previous edition 2003. Fifth edition 2011.

    Standards Referenced By This Book - (Show below) - (Hide below)

    AS/NZS 2500:2004 Guide to the safe use of electricity in patient care
    UNI EN ISO 9170-2 : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS
    AS 1319-1994 Safety signs for the occupational environment (Reconfirmed 2018)
    16/30314880 DC : 0 BS EN ISO 9170-1 - TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    AS/NZS 3111:2009 Approval and test specification - Miniature overcurrent circuit-breakers (Reconfirmed 2020)
    DIN EN ISO 9170-2 E : 2009 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS
    AS 3011.2-1992 Electrical installations - Secondary batteries installed in buildings Sealed cells
    AS/NZS 60320.1:2004 Appliance couplers for household and similar general purposes General requirements (IEC 60320-1, Ed. 2.0 (2001) MOD)
    DIN EN ISO 9170-2:2009-09 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS
    BS EN ISO 9170-1 : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    BS EN ISO 9170-2:2008 Terminal units for medical gas pipeline systems Terminal units for anaesthetic gas scavenging systems
    CSA Z9170.1 : 2011 : R2015 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES, VACUUM, AND ANAESTHETIC GAS SCAVENGING SYSTEMS
    AS/NZS 3100:2009 Approval and test specification - General requirements for electrical equipment
    CSA Z9170.1 : 2011 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES, VACUUM, AND ANAESTHETIC GAS SCAVENGING SYSTEMS
    AS/NZS 1125:2001 Conductors in insulated electric cables and flexible cords (Reconfirmed 2017)
    AS/NZS 3009:1998 Electrical installations - Emergency power supplies in hospitals
    AS/NZS 3112:2004 Approval and test specification - Plugs and socket-outlets
    AS/NZS 4510:1999 Isolated electrical supply systems for medical use (Reconfirmed 2016)
    AS/NZS 3200.1.0-1998 Medical electrical equipment General requirements for safety - Parent Standard
    AS 3011.1-1992 Electrical installations - Secondary batteries installed in buildings - Vented cells Vented cells
    AS/NZS 3000:2007 Electrical installations (known as the Australian/New Zealand Wiring Rules)
    AS/NZS 3008.1.1:2009 Electrical installations - Selection of cables
    AS 2293.1-2005 Emergency escape lighting and exit signs for buildings - System design, installation and operation
    AS/NZS 61009.1:2004 Residual current operated circuit breakers with integral overcurrent protection for household and similar uses (RCBOs) General rules (IEC 61009-1, Ed. 2.1 (2003) MOD)
    AS/NZS 3190:2009 Approval and test specification - Residual current devices (current-operated earth-leakage devices)
    AS/NZS 61008.1:2004 Residual current operated circuit breakers without integral overcurrent protection for household and similar uses (RCCBs) General rules (IEC 61008-1, Ed. 2.1 (2002) MOD)
    AS/NZS 3008.1.2:2010 Electrical installations - Selection of cables
    AS/NZS 3551:2004 Technical management programs for medical devices
    AS/NZS 60898.1:2004 Electrical accessories - Circuit-breakers for overcurrent protection for household and similar installations Circuit-breakers for a.c. operation (IEC 60898-1, Ed. 1.2 (2003) MOD)
    AS/NZS 3123:2005 Approval and test specification - Plugs, socket-outlets and couplers for general industrial application
    AS/NZS 3120:1999 Approval and test specification - Cord extension sockets
    I.S. EN ISO 9170-1:2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    AS/NZS 5000.1:2005 Electric cables - Polymeric insulated For working voltages up to and including 0.6/1 (1.2) kV (Reconfirmed 2017)
    DIN EN ISO 9170-1 E : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    NZS 3019:2004 ELECTRICAL INSTALLATIONS - IN-SERVICE TESTING
    NZS 3003.1:2003 ELECTRICAL INSTALLATIONS - PATIENT AREAS OF HOSPITALS AND MEDICAL AND DENTAL PRACTICES - TESTING REQUIREMENTS
    I.S. EN ISO 9170-2:2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS
    ISO 9170-1:2017 Terminal units for medical gas pipeline systems — Part 1: Terminal units for use with compressed medical gases and vacuum
    ISO 9170-2:2008 Terminal units for medical gas pipeline systems Part 2: Terminal units for anaesthetic gas scavenging systems
    EN ISO 9170-1 : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    UNI EN ISO 9170-1 : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 1: TERMINAL UNITS FOR USE WITH COMPRESSED MEDICAL GASES AND VACUUM
    EN ISO 9170-2 : 2008 TERMINAL UNITS FOR MEDICAL GAS PIPELINE SYSTEMS - PART 2: TERMINAL UNITS FOR ANAESTHETIC GAS SCAVENGING SYSTEMS

    Standards Referencing This Book - (Show below) - (Hide below)

    AS/NZS 5762:2011 In-service safety inspection and testing - Repaired electrical equipment
    AS/NZS 3190:2016 Approval and test specification - Residual current devices (current operated earth-leakage devices)
    AS/NZS 3190:2016 Approval and test specification - Residual current devices (current operated earth-leakage devices)
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective