We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • AS/NZS 3015:2004

    Pending Revision
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Electrical installations - Extra-low voltage d.c. power supplies and service earthing within public telecommunications networks

    Available format(s):  Hardcopy, PDF 1 User, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  09-03-2022

    Language(s):  English

    Published date:  01-01-2004

    Publisher:  Standards Australia

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    Provides requirements for telecommunications ELV d.c. power supplies in restricted access locations of premises that are used by licensed public telecommunications carriers in the provision of public telecommunications networks. It also provides the essential requirements for personal safety and safety from fire while maintaining the viability of the public telecommunications network.

    Scope - (Show below) - (Hide below)

    This Standard sets out requirements for telecommunications ELV d.c. power supplies used by licensed public telecommunications carriers in the provision of public telecommunications networks where—(a) the carrier owns the d.c. power supply; (b) the d.c. power supply is located in a restricted access location; (c) the d.c. power supply is located in premises and land that are owned, leased or otherwise occupied in whole or in part by the telecommunications carrier; and (d) the power supply has a battery with a nominal rating of 2 A.h. or greater at the 10 h rate. It specifies the minimum requirements for personal safety and safety from fire while maintaining the viability of the public telecommunications network.

    General Product Information - (Show below) - (Hide below)

    Committee EL-001
    Development Note Standard has been given Pending Revision status.
    Document Type Standard
    Product Note Pending Revision indicates that as a result of the Aged Standards review process, the document needs updating. If no project proposal, meeting the quality criteria, is received within the 12 month timeframe, the document shall be withdrawn.
    Publisher Standards Australia
    Status Superseded
    Superseded By
    Supersedes

    History - (Show below) - (Hide below)

    First published as AS 3015(Int)-1991.Revised and issued as AS 3015-1993.Third edition 2004. First published as AS 3015(Int)-1991. Revised and issued as AS 3015-1993. Third edition 2004.

    Standards Referenced By This Book - (Show below) - (Hide below)

    AS 3011.1-1992 Electrical installations - Secondary batteries installed in buildings - Vented cells Vented cells
    AS 2676.2-1992 Guide to the installation, maintenance, testing and replacement of secondary batteries in buildings - Sealed cells
    AS/NZS 1768:2007 Lightning protection
    AS/NZS 5000.2:2006 Electric cables - Polymeric insulated For working voltages up to and including 450/750 V (Reconfirmed 2017)
    AS/NZS 3008.1.2:1998 Electrical installations - Selection of cables - Cables for alternating voltages up to and including 0.6/1 kV - Typical New Zealand installation conditions
    AS 2676.1-1992 Guide to the installation, maintenance, testing and replacement of secondary batteries in buildings - Vented cells
    AS 1768-1991 Lightning protection
    AS/NZS 5000.2:1999 Electric cables - Polymeric insulated For working voltages up to and including 450/750 V
    AS/NZS 3100:2002 Approval and test specification - General requirements for electrical equipment
    AS/NZS 4836:2001 Safe working on low-voltage electrical installations
    AS/NZS 3439.2:2002 Low-voltage switchgear and controlgear assemblies Particular requirements for busbar trunking systems (busways)
    AS 3011.2-1992 Electrical installations - Secondary batteries installed in buildings Sealed cells
    AS/NZS 3008.1.1:1998 Electrical installations - Selection of cables - Cables for alternating voltages up to and including 0.6/1 kV - Typical Australian installation conditions
    AS/NZS 5000.1:2005 Electric cables - Polymeric insulated For working voltages up to and including 0.6/1 (1.2) kV (Reconfirmed 2017)
    AS 1170.4-1993 Minimum design loads on structures (known as the SAA Loading Code) - Earthquake loads
    AS/NZS 3000:2000 Electrical installations (known as the Australian/New Zealand Wiring Rules)
    AS/NZS 60079.10:2004 Electrical apparatus for explosive gas atmospheres Classification of hazardous areas (IEC 60079-10:2002 MOD)
    AS/NZS 5000.1:2003 Electric cables - Polymeric insulated For working voltages up to and including 0.6/1 (1.2) kV
    AS 1170.4-2007 Structural design actions Earthquake actions in Australia (Reconfirmed 2018)

    Standards Referencing This Book - (Show below) - (Hide below)

    AS 3011.2:2019 Electrical installations - Secondary batteries installed in buildings Sealed cells
    HB 29-2007 Communications cabling manual - Module 2: Communications cabling handbook
    AS 2676.2:2020 Guide to the installation, maintenance, testing and replacement of secondary batteries in buildings Sealed cells
    AS/NZS 3000:2007 Electrical installations (known as the Australian/New Zealand Wiring Rules)
    AS 2676.1:2020 Installation, maintenance, testing and replacement of secondary batteries in buildings Vented cells
    AS/NZS 2201.1:2007 Intruder alarm systems Client's premises - Design, installation, commissioning and maintenance
    AS 3011.1:2019 Electrical installations - Secondary batteries installed in buildings Vented cells
    AS/NZS 3000:2018 (Unamended Hardcopy + Amendments) Electrical installations (known as the Australian/New Zealand Wiring Rules)
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective