1 - AS/NZS 60922:1998 AUXILIARIES FOR LAMPS-BALLASTS FOR DISCHARGE LAMPS (EXCLUDING TUBULAR FLUORESCENT LAMPS)-GENERAL AND ......
4 - PREFACE
5 - CONTENTS
6 - INTRODUCTION
7 - 1 General
7 - 1.1 Scope and object
7 - 1.2 Normative references
9 - 2 Definitions
9 - 2.1 ballast:
9 - 2.1.1 independent ballast:
9 - 2.1.2 built-in ballast:
9 - 2.1.3 integral ballast:
10 - 2.2 reference ballast:
10 - 2.3 reference lamp:
10 - 2.4 calibration current of a reference ballast:
10 - 2.5 supply voltage:
10 - 2.6 supply current:
10 - 2.7 working voltage:
10 - 2.8 circuit power factor:
10 - 2.9 high power factor ballast:
10 - 2.10 rated maximum operating temperature of a capacitor case:
10 - 2.11 rated maximum operating temperature of a ballast winding:
10 - 2.12 rated temperature rise of a ballast winding:
10 - 2.13 test duration of endurance test:
10 - 2.14 degradation of insulation of a ballast winding:
10 - 2.15 type test:
11 - 2.16 type-test sample:
11 - 2.17 high voltage impulse:
11 - 2.18 ignitor:
11 - 3 General requirements
11 - 4 General notes on tests
11 - 4.1 Tests according to this standard are type tests.
11 - 4.2 The tests are carried out in the order of the clauses, unless otherwise specified.
11 - 4.3
12 - 4.4
12 - 5 Classification
12 - 6 Marking
12 - 6.1 Mandatory markings
13 - 6.2 Information to be provided, if applicable
13 - 6.3 Other information
13 - 6.4 Marking shall be durable and legible.
14 - 7 Protection against accidental contact with live parts
14 - 8 Terminals
14 - 9 Provisions for earthing
15 - 10 Moisture resistance and insulation
16 - 11 High-voltage impulse test
17 - 12 Thermal endurance of windings
18 - 13 Ballast heating
22 - 14 Screws, current-carrying parts and connections
23 - 15 Creepage distances and clearances
24 - 16 Resistance to heat, fire and tracking
25 - 17 Resistance to corrosion
26 - Annex A - Thermal endurance test for windings
29 - Annex B - Use of constants S other than 4500 in T w tests
32 - Annex C - Draught-proof enclosure
33 - Annex D - Method for selection of varistors
33 - D.1 General
33 - D.2 Selection of the varistors
34 - Annex E - Explanations to ballast temperatures
34 - E.1 Endurance
34 - E.2 Ballast heating
35 - E.3 Test arrangement
37 - Annex F - Particular requirements for thermally protected ballasts
37 - F.1 Scope
37 - F.2 Definitions
38 - F.3 General requirements
38 - F.4 General notes on tests
38 - F.5 Classification
38 - F.6 Marking
39 - F.7 Thermal endurance of windings
39 - F.8 Ballast heating