ASTM A 1039/A1039M : 2019 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy Redline , PDF Redline
08-08-2020
English
01-10-2019
1.1This specification covers commercial and structural steel sheet in coils and cut lengths produced by the twin-roll casting process.
1.2The steel sheet is available in the designations listed in Section 4.
1.3The material is available in the following sizes:
| Thickness—0.027 in. [0.7 mm] to 0.078 in. [2.0 mm] |
| Width—up to 79 in. [2000 mm] |
1.4The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Note 1:A description of the Twin-Roll Casting Process is included in Appendix X1.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.