We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • ASTM B 124/B124M : 2013

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes

    Available format(s):  Hardcopy, PDF

    Superseded date:  11-11-2014

    Language(s):  English

    Published date:  01-04-2013

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Add To Cart

    Scope - (Show below) - (Hide below)

    1.1This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging. The following coppers and copper alloys are involved:

    Copper UNS Nos.

    Copper Alloy UNS Nos.

    C11000

    C35330

    C14500

    C36500

    C14700

    C37000

    C37700

    C46400

    C48200

    C48500

    C48600

    C49250

    C49255

    C49260

    C49300

    C49340

    C49350

    C49355

    C49360

    C61900

    C62300

    C63000

    C63200

    C64200

    C64210

    C65500

    C67500

    C67600

    C69150

    C69300

    C70620

    C71520

    C77400

    C87700

    C87710

    C27450




    Note 1Additional information about forging practice and forgings produced from these alloys is given in Appendix X1 and in Specification B283.

    1.2Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee B 05
    Document Type Standard
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    Supersedes
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective