Standard Specification for Hafnium and Hafnium Alloy Strip, Sheet, and Plate

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-04-2019

Publisher

American Society for Testing and Materials

This specification covers the standard requirements for two grades of wrought hafnium and hafnium alloy strip, sheet, and plate: Grade R1 for nuclear applications and Grade R3 for commercial applications.

1.1This specification covers two grades of wrought hafnium and hafnium alloy strip, sheet, and plate as follows:

1.1.1Grade R1 for nuclear applications, and

1.1.2Grade R3 for commercial applications.

1.2Unless a single unit is used, for example corrosion mass gain in mg/dm², the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

1.3The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	B 10
DocumentType	Standard
Pages	9
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM B 776 : 2012

ASTM E 8/E8M : 2024	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 8/E8M : 2016 : REV A : EDT 1	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 29 : 2013 : R2019	Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
ASTM E 8/E8M : 2021	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 29 : 2002	Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
ASTM E 21 : 2020	Standard Test Methods for Elevated Temperature Tension Tests of Metallic Materials
ASTM E 8/E8M : 2022	Standard Test Methods for Tension Testing of Metallic Materials
ASTM E 29 : 2022	Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications