We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • ASTM D 1265 : 1997

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method)

    Available format(s): 

    Superseded date:  11-11-2014

    Language(s): 

    Published date:  10-11-1997

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Sorry this product is not available in your region.

    Add To Cart

    Scope - (Show below) - (Hide below)

    1.1 This practice covers the procedures for obtaining representative samples of liquefied petroleum gases such as propane, butane, or mixtures thereof, in containers other than those used in laboratory testing apparatus. These procedures are considered adequate for obtaining representative samples for all routine tests for LP gases required by Specification D1835 except analysis by Test Method D2163. They are not intended for obtaining samples to be used for compositional analysis. A sample procedure that avoids changes in composition must be used for compositional analysis.

    Note 1-Practice D3700 describes a recommended method for obtaining a representative sample of a hydrocarbon fluid and the subsequent preparation of that sample for laboratory analysis.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee D 02
    Document Type Standard Practice
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By

    Standards Referenced By This Book - (Show below) - (Hide below)

    ASTM D 7901 : 2014 : REV B Standard Specification for Dimethyl Ether for Fuel Purposes
    ASTM D 1157 : 1991 : R2014 Standard Test Method for Total Inhibitor Content (TBC) of Light Hydrocarbons
    ASTM D 1657 : 2012 : R2017 Standard Test Method for Density or Relative Density of Light Hydrocarbons by Pressure Hydrometer
    ASTM D 2713 : 2015 : EDT 1 Standard Test Method for Dryness of Propane (Valve Freeze Method)
    ASTM D 2712 : 2018 : REV A Standard Test Method for Determination of Hydrocarbon Impurities in High Purity Propylene by Gas Chromatography
    ASTM D 2420 : 2013 : R2018 Standard Test Method for Hydrogen Sulfide in Liquefied Petroleum (LP) Gases (Lead Acetate Method)
    ASTM D 1838 : 2016 Standard Test Method for Copper Strip Corrosion by Liquefied Petroleum (LP) Gases
    ASTM D 1267 : 2018 Standard Test Method for Gauge Vapor Pressure of Liquefied Petroleum (LP) Gases (LP-Gas Method)
    ASTM D 2650 : 2010 : R2015 Standard Test Method for Chemical Composition of Gases by Mass Spectrometry
    ASTM D 3700 : 2016 Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder
    ASTM D 6667 : 2014 : R2019 Standard Test Method for Determination of Total Volatile Sulfur in Gaseous Hydrocarbons and Liquefied Petroleum Gases by Ultraviolet Fluorescence
    ASTM D 6228 : 2019 Standard Test Method for Determination of Sulfur Compounds in Natural Gas and Gaseous Fuels by Gas Chromatography and Flame Photometric Detection
    ASTM D 4057 : 2012 : R2018 Standard Practice for Manual Sampling of Petroleum and Petroleum Products
    ASTM E 126 : 2019 Standard Test Method for Inspection, Calibration, and Verification of ASTM Hydrometers
    ASTM D 6849 : 2013 Standard Practice for Storage and Use of Liquefied Petroleum Gases (LPG) in Sample Cylinders for LPG Test Methods
    ASTM D 1015 : 2005 : R2015 Standard Test Method for Freezing Points of High-Purity Hydrocarbons (Withdrawn 2019)
    ASTM D 2163 : 2014 : R2019 Standard Test Method for Determination of Hydrocarbons in Liquefied Petroleum (LP) Gases and Propane/Propene Mixtures by Gas Chromatography
    ASTM D 6968 : 2003 : R2015 Standard Test Method for Simultaneous Measurement of Sulfur Compounds and Minor Hydrocarbons in Natural Gas and Gaseous Fuels by Gas Chromatography and Atomic Emission Detection
    ASTM D 7756 : 2019 Standard Test Method for Residues in Liquefied Petroleum (LP) Gases by Gas Chromatography with Liquid, On-Column Injection
    ASTM E 1655 : 2017 Standard Practices for Infrared Multivariate Quantitative Analysis
    ASTM D 7676 : 2018 Standard Practice for Screening Organic Halides Contained in Hydrogen or Other Gaseous Fuels
    ASTM D 7828 : 2012 Standard Test Method for Determination of Residue Composition in Liquefied Petroleum Gas (LPG) Using Automated Thermal Desorption/Gas Chromatography (ATD/GC) (Withdrawn 2021)
    ASTM D3764:2019 Standard Practice for Validation of the Performance of Process Stream Analyzer Systems
    ASTM D 6897 : 2016 Standard Test Method for Vapor Pressure of Liquefied Petroleum Gases (LPG) (Expansion Method)
    ASTM D 5799 : 1995 : R2014 Standard Test Method for Determination of Peroxides in Butadiene
    ASTM D 1835 : 2018 : REV A Standard Specification for Liquefied Petroleum (LP) Gases
    ASTM D 7551 : 2010 : R2015 Standard Test Method for Determination of Total Volatile Sulfur in Gaseous Hydrocarbons and Liquefied Petroleum Gases and Natural Gas by Ultraviolet Fluorescence
    ASTM D 7423 : 2017 Standard Test Method for Determination of Oxygenates in C2, C3, C4, and C5 Hydrocarbon Matrices by Gas Chromatography and Flame Ionization Detection
    ASTM D 3246 : 2015 Standard Test Method for Sulfur in Petroleum Gas by Oxidative Microcoulometry
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective