ASTM D 2163 : 2014 : R2019
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Method for Determination of Hydrocarbons in Liquefied Petroleum (LP) Gases and Propane/Propene Mixtures by Gas Chromatography
Hardcopy , PDF
17-03-2023
English
19-06-2019
This test method covers the quantitative determination of individual hydrocarbons in liquefied petroleum (LP) gases and mixtures of propane and propene, excluding high-purity propene in the range of C1to C5.
1.1This test method covers the quantitative determination of individual hydrocarbons in liquefied petroleum (LP) gases and mixtures of propane and propene, excluding high-purity propene in the range of C1 to C5. Component concentrations are determined in the range of 0.01 to 100 percent by volume.
1.2This test method does not fully determine hydrocarbons heavier than C5 and non-hydrocarbon materials, and additional tests may be necessary to fully characterize an LPG sample.
1.3The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| Committee |
D 02
|
| DocumentType |
Test Method
|
| Pages |
12
|
| ProductNote |
THIS STANDARD ALSO REFERS TO CAN/CGSB 3.0 No. 14.3, GPA Std 2145-03.
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 8178-5:2021 | Equivalent |
| ASTM D 7901 : 2014 : REV B | Standard Specification for Dimethyl Ether for Fuel Purposes |
| ASTM D 3588 : 1998 : R2017 | Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels |
| ASTM D 6849 : 2013 | Standard Practice for Storage and Use of Liquefied Petroleum Gases (LPG) in Sample Cylinders for LPG Test Methods |
| ASTM D 5273 : 2018 | Standard Guide for Analysis of Propylene Concentrates |
| ASTM D 1835 : 2018 : REV A | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 7756 : 2019 | Standard Test Method for Residues in Liquefied Petroleum (LP) Gases by Gas Chromatography with Liquid, On-Column Injection |
| ASTM D 6667 : 2021 | Standard Test Method for Determination of Total Volatile Sulfur in Gaseous Hydrocarbons and Liquefied Petroleum Gases by Ultraviolet Fluorescence |
| ASTM F 400 : 2020 | Standard Consumer Safety Specification for Lighters |
| ASTM D 7901 : 2020 | Standard Specification for Dimethyl Ether for Fuel Purposes |
| ASTM F 2201 : 2020 | Standard Consumer Safety Specification for Utility Lighters |
| ASTM D 6849 : 2022 | Standard Practice for Storage and Use of Liquefied Petroleum Gases (LPG) in Sample Cylinders for LPG Test Methods |
| ASTM D 8094 : 2021 | Standard Test Method for Determination of Water Content of Liquefied Petroleum Gases (LPG) Using an Online Electronic Moisture Analyzer |
| ASTM D 3588 : 1998 : R2017 : EDT 1 | Standard Practice for Calculating Heat Value, Compressibility Factor, and Relative Density of Gaseous Fuels |
| ASTM F 2201 : 2019 | Standard Consumer Safety Specification for Utility Lighters |
| ASTM F 400 : 2019 | Standard Consumer Safety Specification for Lighters |
| ASTM D 2598 : 2016 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 6729 : 2014 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100 Metre Capillary High Resolution Gas Chromatography |
| ASTM D 2598 : 2021 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 6729 : 2001 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100 Meter Capillary High Resolution Gas Chromatography |
| ASTM D 1265 : 1997 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 2421 : 2002 : R2007 | Standard Practice for Interconversion of Analysis of C<i><inf>5</inf></i> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
| ASTM D 2421 : 2021 | Standard Practice for Interconversion of Analysis of C<emph type="ital"><inf>5</inf ></emph> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
| ASTM D 3700 : 2001 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 1835 : 1997 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2421 : 1995 | Standard Practice for Interconversion of Analysis of C<sub>5</sub> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Weight Basis |
| ASTM E 1510 : 1995 : R2013 : EDT 1 | Standard Practice for Installing Fused Silica Open Tubular Capillary Columns in Gas Chromatographs |
| ASTM D 3700 : 2014 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 2421 : 2018 | Standard Practice for Interconversion of Analysis of C<emph type="ital"><inf>5</inf ></emph> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
| ASTM D 3700 : 1994 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 1835 : 2018 : REV A | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 1835 : 2012 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2421 : 2001 | Standard Practice for Interconversion of Analysis of C<sub>5</sub> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Weight Basis |
| ASTM D 6729 : 2004 : EDT 1 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100 Metre Capillary High Resolution Gas Chromatography |
| ASTM D 2598 : 2012 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 6729 : 2004 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100 Meter Capillary High Resolution Gas Chromatography |
| ASTM D 2421 : 2002 | Standard Practice for Interconversion of Analysis of C<sub>5</sub> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Weight Basis |
| ASTM D 3700 : 2021 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 2598 : 2002 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM E 1510 : 1995 : R2000 | Standard Practice for Installing Fused Silica Open Tubular Capillary Columns in Gas Chromatographs |
| ASTM D 1835 : 2003 : REV A | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM E 1510 : 1995 : R2005 | Standard Practice for Installing Fused Silica Open Tubular Capillary Columns in Gas Chromatographs |
| ASTM E 1510 : 1995 : R2021 | Standard Practice for Installing Fused Silica Open Tubular Capillary Columns in Gas Chromatographs |
| ASTM E 355 : 1996 : R2021 : EDT 1 | Standard Practice for Gas Chromatography Terms and Relationships |
| ASTM D 1835 : 2003 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 1835 : 2013 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2421 : 2013 | Standard Practice for Interconversion of Analysis of C<emph type="ital"><inf>5</inf ></emph> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
| ASTM D 1835 : 2020 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 1835 : 2018 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2598 : 1996 : R2001 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 2421 : 2021 : EDT 1 | Standard Practice for Interconversion of Analysis of C<emph type="ital"><inf>5</inf ></emph> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
| ASTM E 1510 : 1995 | Standard Practice for Installing Fused Silica Open Tubular Capillary Columns in Gas Chromatographs |
| ASTM D 1265 : 2004 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 3700 : 2012 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 6729 : 2004 : R2009 | Standard Test Method for Determination of Individual Components in Spark Ignition Engine Fuels by 100 Metre Capillary High Resolution Gas Chromatography |
| ASTM D 1835 : 2022 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 3700 : 2007 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM D 1835 : 2016 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 1265 : 2011 : R2017 : EDT 1 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM D 1835 : 2011 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2598 : 2016 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 1265 : 2005 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 2598 : 2002 : R2007 | Standard Practice for Calculation of Certain Physical Properties of Liquefied Petroleum (LP) Gases from Compositional Analysis |
| ASTM D 1265 : 2004 : REV A | Standard Practice for Sampling Liquefied Petroleum (LP) Gases (Manual Method) |
| ASTM D 1265 : 2011 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM D 3700 : 2016 | Standard Practice for Obtaining LPG Samples Using a Floating Piston Cylinder |
| ASTM E 355 : 1996 : R2014 | Standard Practice for Gas Chromatography Terms and Relationships |
| ASTM D 1265 : 2022 | Standard Practice for Sampling Liquefied Petroleum (LP) Gases, Manual Method |
| ASTM D 1835 : 2005 | Standard Specification for Liquefied Petroleum (LP) Gases |
| ASTM D 2421 : 2019 | Standard Practice for Interconversion of Analysis of C<emph type="ital"><inf>5</inf ></emph> and Lighter Hydrocarbons to Gas-Volume, Liquid-Volume, or Mass Basis |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.