• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM D 2172 : 1995

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Methods for Quantitative Extraction of Bitumen From Bituminous Paving Mixtures
Superseded date

11-11-2014

Published date

10-12-2001

1.1 These test methods cover the quantitative determination of bitumen in hot-mixed paving mixtures and pavement samples. Aggregate obtained by these test methods may be used for sieve analysis using Test Method C 117 and Test Method C 136.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.

Note 1—The results obtained by these test methods may be affected by the age of the material tested, with older samples tending to yield slightly lower bitumen content. Best quantitative results are obtained when the test is made on mixtures and pavements shortly after their preparation. It is difficult to remove all the asphalt when some aggregates are used and some chlorides may remain within the mineral matter affecting the measured asphalt content.

Committee
D 04
DocumentType
Test Method
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

ASTM D 6607 : 2000 : R2015 Standard Practice for Inclusion of Precision Statement Variation in Specification Limits
ASTM D 5710/D5710M : 2015 Standard Specification for Trinidad Lake Modified Asphalt
ASTM D 4057 : 2012 : R2018 Standard Practice for Manual Sampling of Petroleum and Petroleum Products
ASTM D 6608 : 2012 Standard Practice for the Identification of Trinidad Lake Asphalt in Asphalt Mixes
ASTM D 4215 : 2007 : R2013 Standard Specification for Cold-Mixed, Cold-Laid Bituminous Paving Mixtures
ASTM D 6995 : 2005 : R2013 Standard Test Method for Determining Field VMA based on the Maximum Specific Gravity of the Mix (G<inf>mm</inf>)
ASTM D 5444 : 2015 Standard Test Method for Mechanical Size Analysis of Extracted Aggregate
ASTM D 4469 : 2017 Standard Practice for Calculating Percent Asphalt Absorption by the Aggregate in Asphalt Mixtures
ASTM D 1856 : 2009 : R2015 Standard Test Method for Recovery of Asphalt From Solution by Abson Method
ASTM D 4887/D4887M : 2011 : R2016 Standard Practice for Preparation of Viscosity Blends for Hot Recycled Asphalt Materials
ASTM D 4383 : 2018 Standard Specification for Plowable, Raised Retroreflective Pavement Markers

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.