ASTM D 2259 : 2002 : R2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Method for Shrinkage of Yarns
Hardcopy , PDF
26-08-2020
English
01-01-2016
CONTAINED IN VOL. 07.01, 2016 Describes the shrinkage of yarns in skein form when treated in boiling water, dry heat, saturated steam, or solvents.
1.1This test method is used to determine the shrinkage of yarns in skein form when treated in boiling water, dry heat, saturated steam, or solvents. This test method is applicable to yarns made from any fiber or combination of fibers where the tex of the yarn is known or can be determined. This test method is not recommended for elastomeric yarns and those yarns that stretch more than 5 % under the tension loadings prescribed, although it has been used for the latter.
Note 1:Procedures for determining yarn shrinkage and bulk properties of textured yarns are covered in Test Method D4031.
1.2This test method shows the values in both SI and inch-pound units. “SI” units is the technically correct name for the system of metric units known as the International System of Units. “Inch-pound” units is the technically correct name for the customary units used in the United States. The values stated in either SI units or in other units shall be regarded as standard. The values expressed in each system may not be exact equivalents; therefore each system must be used independently of the other without combining in any way.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| Committee |
D 13
|
| DocumentType |
Test Method
|
| Pages |
6
|
| ProductNote |
Reconfirmed 2016
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ASTM D 4849 : 2013 : R2018 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 3218 : 2007 : R2018 | Standard Specification for Polyolefin Monofilaments |
| ASTM D 1907 : 1997 | Standard Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method |
| ASTM D 3990 : 1999 : R2008 | Standard Terminology Relating to Fabric Defects |
| ASTM D 4849 : 2013 : EDT 3 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 3990 : 1999 : R2004 | Standard Terminology Relating to Fabric Defects |
| ASTM D 2258 : 1999 : R2012 | Standard Practice for Sampling Yarn for Testing |
| ASTM D 2258 : 1999 | Standard Practice for Sampling Yarn for Testing |
| ASTM D 3888 : 2007 | Standard Terminology for Yarn Spinning Systems |
| ASTM D 4848 : 1998 : R2004 : EDT 1 | Standard Terminology Related to Force, Deformation and Related Properties of Textiles |
| ASTM D 1059 : 1997 | Standard Test Method for Yarn Number Based on Short-Length Specimens |
| ASTM D 1907 : 2007 | Standard Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method |
| ASTM D 2258 : 1999 : R2005 | Standard Practice for Sampling Yarn for Testing |
| ASTM D 1907 : 2001 | Standard Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method |
| ASTM D 4849 : 2013 : EDT 2 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4849 : 2002 : REV A | Standard Terminology Relating to Yarns and Fibers |
| ASTM D 1776 : 1998 : EDT 1 | Standard Practice for Conditioning and Testing Textiles |
| ASTM D 3990 : 2012 : R2016 | Standard Terminology Relating to Fabric Defects |
| ASTM D 4031 : 2007 : R2012 | Standard Test Method for Bulk Properties of Textured Yarns |
| ASTM D 4849 : 2013 : R2018 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4849 : 2002 : REV B | Standard Terminology Relating to Yarns and Fibers |
| ASTM D 1776 : 1967 : EDT 1 | Standard Method Of Conditioning Textiles And Textile Products For Testing |
| ASTM D 3888 : 1995 | Standard Terminology Relating to Open-End Spinning |
| ASTM D 4849 : 2002 : REV B : R2007 : EDT 2 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4848 : 1998 : R2018 | Standard Terminology Related to Force, Deformation and Related Properties of Textiles |
| ASTM D 4031 : 1995 : REV A | Standard Test Method for Bulk Properties of Textured Yarns |
| ASTM D 4849 : 2002 : REV B : EDT 1 | Standard Terminology Relating to Yarns and Fibers |
| ASTM D 4031 : 2007 | Standard Test Method for Bulk Properties of Textured Yarns |
| ASTM D 4849 : 2002 : REV B : R2007 : EDT 1 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 1059 : 2001 | Standard Test Method for Yarn Number Based on Short-Length Specimens (Withdrawn 2010) |
| ASTM D 3888 : 2012 | Standard Terminology for Yarn Spinning Systems |
| ASTM D 1776 : 2004 | Standard Practice for Conditioning and Testing Textiles |
| ASTM D 4031 : 2007 : R2018 | Standard Test Method for Bulk Properties of Textured Yarns |
| ASTM D 3888 : 2015 | Standard Terminology for Yarn Spinning Systems |
| ASTM D 1776 : 2008 : EDT 1 | Standard Practice for Conditioning and Testing Textiles |
| ASTM D 1776 : 2008 | Standard Practice for Conditioning and Testing Textiles |
| ASTM D 3990 : 2012 : EDT 1 | Standard Terminology Relating to Fabric Defects |
| ASTM D 4848 : 1998 | Standard Terminology of Force, Deformation and Related Properties of Textiles |
| ASTM D 4031 : 2001 | Standard Test Method for Bulk Properties of Textured Yarns |
| ASTM D 3888 : 2015 : REDLINE | Standard Terminology for Yarn Spinning Systems |
| ASTM D 1059 : 2017 | Standard Test Method for Yarn Number Based on Short-Length Specimens |
| ASTM D 1059 : 2017 | Standard Test Method for Yarn Number Based on Short-Length Specimens |
| ASTM D 3888 : 2007 : EDT 1 | Standard Terminology for Yarn Spinning Systems |
| ASTM D 4849 : 2002 : REV B : R2007 | Standard Terminology Relating to Yarns and Fibers |
| ASTM D 3990 : 1999 | Standard Terminology Relating to Fabric Defects |
| ASTM D 4849 : 2013 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4849 : 2002 : REV B : R2007 : EDT 3 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4849 : 2013 : EDT 1 | Standard Terminology Related to Yarns and Fibers |
| ASTM D 4848 : 1998 : R2004 | Standard Terminology of Force, Deformation and Related Properties of Textiles |
| ASTM D 3990 : 2012 | Standard Terminology Relating to Fabric Defects |
| ASTM D 4848 : 1998 : R2012 | Standard Terminology Related to Force, Deformation and Related Properties of Textiles |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.