Standard Test Methods for Fibrous-Insulated Magnet Wire

Available format(s)

PDF

Language(s)

English

Published date

19-03-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 10.02, 2018 Defines the testing of fibrous-insulated electrical conductors, commonly referred to as magnet wire, which are used in electrical apparatus.

1.1These test methods cover the testing of fibrous-insulated electrical conductors, commonly referred to as magnet wire, which are used in electrical apparatus. The test methods are intended primarily for evaluation of the electrical insulating materials used. It is intended that these test methods be used, except where modified by individual specifications for particular applications.

1.1.1These test methods apply to those magnet wires that are fiber-covered and in which the substrate is bare conductor or is coated with an underlying insulating film as covered by Test Methods D1676. Fiber-covered wires are produced by serving helically or wrapping fibers or fibrous-tape insulation uniformly around the wire in single and multiple layers. The served or wrapped materials are bonded or not bonded to the underlying wire.

1.2The test methods appear in the following sections:

Procedure	Section
Measurement of Dimensions	7
Electrical Resistance of Conductors	5
Elongation	4
Adhesion and Flexibility	8
Fibrous Coverage	6
Dielectric Breakdown Voltage	9

1.3This standard and IEC 60851 are similar if not equivalent in technical content.

1.4This standard and NEMA MW 1000 are similar if not equivalent in technical content.

1.5The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 8.4.1 and 9.4.1 for specific caution statements.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 09
DocumentType	Redline
Pages	8
PublisherName	American Society for Testing and Materials
Status	Current

NEMA MW 1000 : 2016	MAGNET WIRE
ASTM D 1711 : 2015 : REDLINE	Standard Terminology Relating to Electrical Insulation
ASTM E 8 : 2004	Standard Test Methods for Tension Testing of Metallic Materials
ASTM B 193 : 2016 : REDLINE	Standard Test Method for Resistivity of Electrical Conductor Materials
ASTM D 5423 : 2014	Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation