Standard Practice for Quality Assurance of Pressure-Sensitive Tapes

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

01-08-2019

Publisher

American Society for Testing and Materials

This practice contains uniform quality assurance provisions for pressure-sensitive tapes and establishes sampling plans and procedures for acceptance inspection.

1.1This practice contains uniform quality assurance provisions for pressure-sensitive tapes and establishes sampling plans and procedures for acceptance inspection.

1.2Limitations:

1.2.1This practice only includes procedures for when an upper or a lower specification limit is given. It does not provide for double, both minimum and maximum, specification limits.

Note 1:When double specification limits are given (applies to variables testing only), use may be made of Table C-3 and Example C-3 of ANSI/ASQC Z1.9.

1.2.2The variables sampling plans apply to a single quality characteristic. Having obtained the sample and the responses to the physical property tests, acceptance is determined on one quality characteristic at a time. The process is repeated for each additional characteristic.

1.2.3The variables sampling plans require that the response to each quality characteristic is normally distributed either directly or by transformation. If this is not known, the potential user of this practice should seek the counsel of someone with sufficient understanding of statistical techniques to provide that information.

1.3The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 10
DocumentType	Standard Practice
Pages	6
ProductNote	THIS STANDARD ALSO REFERS TO :ANSI/ASQC A2,ANSI/ASQC A3,ANSI/ASQC Q94,ANSI/ASQC Z1.4,ANSI/ASQC Z1.9
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 3715/D3715M : 1998 : R2011

ASTM D 996 : 2023	Standard Terminology of Packaging and Distribution Environments
ASTM D 996 : 2016	Standard Terminology of Packaging and Distribution Environments
ASTM D 996 : 2010	Standard Terminology of Packaging and Distribution Environments