ASTM D 5291 : 2016 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Standard Test Methods for Instrumental Determination of Carbon, Hydrogen, and Nitrogen in Petroleum Products and Lubricants
05-01-2022
English
14-10-2016
CONTAINED IN VOL. 05.02, 2016 Defines the instrumental determination of carbon, hydrogen, and nitrogen in laboratory samples of petroleum products and lubricants.
1.1These test methods cover the instrumental determination of carbon, hydrogen, and nitrogen in laboratory samples of petroleum products and lubricants. Values obtained represent the total carbon, the total hydrogen, and the total nitrogen.
1.2These test methods are applicable to samples such as crude oils, fuel oils, additives, and residues for carbon and hydrogen and nitrogen analysis. These test methods were tested in the concentration range of at least 75 mass % to 87 mass % for carbon, at least 9 mass % to 16 mass % for hydrogen, and <0.1 mass % to 2 mass % for nitrogen.
1.3The nitrogen test method is not applicable to light materials or those containing <0.75 mass % nitrogen, or both, such as gasoline, jet fuel, naphtha, diesel fuel, or chemical solvents.
1.3.1However, using Test Method D levels of 0.1 mass % nitrogen in lubricants could be determined.
1.4These test methods are not recommended for the analysis of volatile materials such as gasoline, gasoline-oxygenate blends, or gasoline type aviation turbine fuels.
1.5The results of these tests can be expressed as mass % carbon, hydrogen or nitrogen.
1.6The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.7This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| Committee |
D 02
|
| DevelopmentNote |
Supersedes ASTM UOP 866. (10/2010)
|
| DocumentType |
Redline
|
| Pages |
10
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| DIN EN 16900 E : 2017 | FAST PYROLYSIS BIO-OILS FOR INDUSTRIAL BOILERS - REQUIREMENTS AND TEST METHODS |
| ISO 16620-2:2015 | Plastics Biobased content Part 2: Determination of biobased carbon content |
| BS EN 16640:2017 | Bio-based products. Bio-based carbon content. Determination of the bio-based carbon content using the radiocarbon method |
| MIL-DTL-83133 Revision J:2015 | TURBINE FUEL, AVIATION, KEROSENE TYPE, JP-8 (NATO F-34), NATO F-35, AND JP-8+100 (NATO F-37) |
| BS EN 16900:2017 | Fast pyrolysis bio-oils for industrial boilers. Requirements and test methods |
| MIL-DTL-5624 Revision W:2016 | TURBINE FUEL, AVIATION, GRADES JP-4 AND JP-5 |
| PD CEN/TR 17103:2017 | Petroleum and related products. Fast pyrolysis bio-oils for stationary internal combustion engines. Quality determination |
| ASTM D 6823 : 2008 | Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils |
| ASTM D 7171 : 2016 : REDLINE | Standard Test Method for Hydrogen Content of Middle Distillate Petroleum Products by Low-Resolution Pulsed Nuclear Magnetic Resonance Spectroscopy |
| MIL-DTL-16884 Revision P:2017 | FUEL, NAVAL DISTILLATE |
| I.S. EN 16785-1:2015 | BIO-BASED PRODUCTS - BIO-BASED CONTENT - PART 1: DETERMINATION OF THE BIO-BASED CONTENT USING THE RADIOCARBON ANALYSIS AND ELEMENTAL ANALYSIS |
| S.R. CEN/TS 16640:2014 | BIO-BASED PRODUCTS - DETERMINATION OF THE BIO BASED CARBON CONTENT OF PRODUCTS USING THE RADIOCARBON METHOD |
| DIN EN 16640:2015-09 (Draft) | BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| I.S. EN 16640:2017 | BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| ASTM D 7578 : 2015-06 | GUIDE FOR CALIBRATION REQUIREMENTS FOR ELEMENTAL ANALYSIS OF PETROLEUM PRODUCTS AND LUBRICANTS |
| ASTM D 6006 : 2017 : REDLINE | Standard Guide for Assessing Biodegradability of Hydraulic Fluids |
| ASTM D 4808 : 2017 : REDLINE | Standard Test Methods for Hydrogen Content of Light Distillates, Middle Distillates, Gas Oils, and Residua by Low-Resolution Nuclear Magnetic Resonance Spectroscopy |
| MIL-DTL-83133 Revision K:2018 | TURBINE FUEL, AVIATION, KEROSENE TYPE, JP-8 (NATO F-34), NATO F-35, AND JP-8+100 (NATO F-37) |
| CEN/TS 16640 : 2014 | BIO-BASED PRODUCTS - DETERMINATION OF THE BIO BASED CARBON CONTENT OF PRODUCTS USING THE RADIOCARBON METHOD |
| EN 16640:2017/AC:2017 | BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| API TR 2572 : 2013 | CARBON CONTENT, SAMPLING, AND CALCULATION |
| S.R. CEN/TR 17103:2017 | FAST PYROLYSIS BIO-OILS FOR STATIONARY INTERNAL COMBUSTION ENGINES - QUALITY DETERMINATION |
| ASTM D 6823 : 2008 : R2013 | Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils |
| BIS IS 13656 : 2014 | INTERNAL COMBUSTION ENGINE CRANKCASE OILS FOR AUTOMOTIVE APPLICATION (DIESEL AND GASOLINE) - SPECIFICATION |
| ASTM D 3343 : 2016 : REDLINE | Standard Test Method for Estimation of Hydrogen Content of Aviation Fuels |
| DIN EN 16640:2017-08 | BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| ASME PTC4.3 : 2017 | PERFORMANCE TEST CODES - AIR HEATERS |
| I.S. EN 16900:2017 | FAST PYROLYSIS BIO-OILS FOR INDUSTRIAL BOILERS - REQUIREMENTS AND TEST METHODS |
| BS ISO 16620-4:2016 | Plastics. Biobased content Determination of biobased mass content |
| 14/30304809 DC : 0 | BS EN 16785 - BIO-BASED PRODUCTS - DETERMINATION OF THE BIO-BASED CONTENT USING THE RADIOCARBON ANALYSIS AND ELEMENTAL ANALYSIS |
| ISO 16620-4:2016 | Plastics — Biobased content — Part 4: Determination of biobased mass content |
| FM 6930 : 2009 | FLAMMABILITY CLASSIFICATION OF INDUSTRIAL FLUIDS |
| ASTM D 7666 : 2012 | Standard Specification for Triglyceride Burner Fuel |
| DIN EN 16900:2015-09 (Draft) | FAST PYROLYSIS BIO-OILS FOR INDUSTRIAL BOILERS - REQUIREMENTS AND TEST METHODS |
| UNE-EN 16640:2017 | Bio-based products - Bio-based carbon content - Determination of the bio-based carbon content using the radiocarbon method |
| MIL PRF 16884 : K | FUEL, NAVAL DISTILLATE |
| PD CEN/TR 16721:2014 | Bio-based products. Overview of methods to determine the bio-based content |
| BS ISO 2314:2009 | Gas turbines. Acceptance tests |
| BS EN 16785-1:2015 | Bio-based products. Bio-based content Determination of the bio-based content using the radiocarbon analysis and elemental analysis |
| DIN EN 16785-1 E : 2016 | BIO-BASED PRODUCTS - BIO-BASED CONTENT - PART 1: DETERMINATION OF THE BIO-BASED CONTENT USING THE RADIOCARBON ANALYSIS AND ELEMENTAL ANALYSIS |
| UNE-EN 16785-1:2016 | Bio-based products - Bio-based content - Part 1: Determination of the bio-based content using the radiocarbon analysis and elemental analysis |
| 15/30326869 DC : 0 | BS EN 16640 - BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| UNI CEN/TS 16640 : 2014 | BIO-BASED PRODUCTS - DETERMINATION OF THE BIO BASED CARBON CONTENT OF PRODUCTS USING THE RADIOCARBON METHOD |
| UNI/TS 11446 : 2012 | PYROLYTIC BIOLIQUIDS - CLASSIFICATION AND SPECIFICATIONS FOR ENERGY USE |
| BS ISO 16620-2:2015 | Plastics. Biobased content Determination of biobased carbon content |
| UNE-EN 16900:2017 | Fast pyrolysis bio-oils for industrial boilers - Requirements and test methods |
| EN 16785-1:2015 | Bio-based products - Bio-based content - Part 1: Determination of the bio-based content using the radiocarbon analysis and elemental analysis |
| EN 16900:2017 | Fast pyrolysis bio-oils for industrial boilers - Requirements and test methods |
| DIN EN 16640 E : 2017 | BIO-BASED PRODUCTS - BIO-BASED CARBON CONTENT - DETERMINATION OF THE BIO-BASED CARBON CONTENT USING THE RADIOCARBON METHOD |
| DIN EN 16785-1:2016-03 | BIO-BASED PRODUCTS - BIO-BASED CONTENT - PART 1: DETERMINATION OF THE BIO-BASED CONTENT USING THE RADIOCARBON ANALYSIS AND ELEMENTAL ANALYSIS |
| ASTM UOP 703 : 2009 | Carbon on Catalysts by Induction Furnace Combustion and Infrared Detection |
| 15/30291640 DC : 0 | BS ISO 16620-4 - PLASTICS - BIOBASED CONTENT - PART 4: DETERMINATION OF THE BIOBASED MASS CONTENT |
| PD CEN/TS 16640:2014 | Bio-based products. Determination of the bio based carbon content of products using the radiocarbon method |
| 14/30291633 DC : 0 | BS ISO 16620-2 - PLASTICS - BIOBASED CONTENT - PART 2: DETERMINATION OF BIOBASED CARBON CONTENT |
| 15/30325842 DC : 0 | BS EN 16900 - FAST PYROLYSIS BIO-OILS FOR INDUSTRIAL BOILERS - REQUIREMENTS AND TEST METHODS |
| S.R. CEN/TR 16721:2014 | BIO-BASED PRODUCTS - OVERVIEW OF METHODS TO DETERMINE THE BIO-BASED CONTENT |
| ISO 2314:2009 | Gas turbines — Acceptance tests |
| ASTM D 8056 : 2016 | Standard Guide for Elemental Analysis of Crude Oil |
| CEN/TR 17103:2017 | Petroleum and related products - Fast pyrolysis bio-oils for stationary internal combustion engines - Quality determination |
| CEN/TR 16721 : 2014 | BIO-BASED PRODUCTS - OVERVIEW OF METHODS TO DETERMINE THE BIO-BASED CONTENT |
Please Login or Create an Account so you can add users to your Multi user PDF Later.
Important note : All end users must be registered with an Account prior to user licenses being assigned.
Users cannot be edited or removed once added to your Multi user PDF.
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.