Standard Guide for Prediction of Analyzer Sample System Lag Times

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

31-12-2021

Publisher

American Society for Testing and Materials

1.1This guide covers the application of routine calculations to estimate sample system lag time, in seconds, for gas, liquid, and mixed phase systems.

1.2This guide considers the sources of lag time from the process sample tap, tap conditioning, sample transport, pre-analysis conditioning and analysis.

1.3Lag times are estimated based on a prediction of flow characteristics, turbulent, non turbulent, or laminar, and the corresponding purge requirements.

1.4Mixed phase systems prevent reliable representative sampling so system lag times should not be used to predict sample representation of a mixed phase stream.

1.5The values stated in inch-pound units are to be regarded as standard. Other units of measurement are included in this standard and Appendix X1 examples where normally seen in industry.

1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	D 02
DocumentType	Guide
Pages	9
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM D 7278 : 2016

ASTM D 7825 : 2018	Standard Practice for Generating a Process Stream Property Value through Application of a Process Stream Analyzer
ASTM D 8321 : 2021	Standard Practice for Development and Validation of Multivariate Analyses for Use in Predicting Properties of Petroleum Products, Liquid Fuels, and Lubricants based on Spectroscopic Measurements
ASTM D 7453 : 2018	Standard Practice for Sampling of Petroleum Products for Analysis by Process Stream Analyzers and for Process Stream Analyzer System Validation
ASTM D 7808 : 2018	Standard Practice for Determining the Site Precision of a Process Stream Analyzer on Process Stream Material
ASTM D 6122 : 2021	Standard Practice for Validation of the Performance of Multivariate Online, At-Line, Field and Laboratory Infrared Spectrophotometer, and Raman Spectrometer Based Analyzer Systems

ASTM D 6122 : 2021	Standard Practice for Validation of the Performance of Multivariate Online, At-Line, Field and Laboratory Infrared Spectrophotometer, and Raman Spectrometer Based Analyzer Systems
ASTM D 8321 : 2021	Standard Practice for Development and Validation of Multivariate Analyses for Use in Predicting Properties of Petroleum Products, Liquid Fuels, and Lubricants based on Spectroscopic Measurements
ASTM D 3764 : 2019	Standard Practice for Validation of the Performance of Process Stream Analyzer Systems
ASTM D 3764 : 2022	Standard Practice for Validation of the Performance of Process Stream Analyzer Systems
ASTM D 6122 : 2023	Standard Practice for Validation of the Performance of Multivariate Online, At-Line, Field and Laboratory Infrared Spectrophotometer, and Raman Spectrometer Based Analyzer Systems
ASTM D 3764 : 2023	Standard Practice for Validation of the Performance of Process Stream Analyzer Systems
ASTM D 8321 : 2022	Standard Practice for Development and Validation of Multivariate Analyses for Use in Predicting Properties of Petroleum Products, Liquid Fuels, and Lubricants based on Spectroscopic Measurements
ASTM D 6122 : 2022	Standard Practice for Validation of the Performance of Multivariate Online, At-Line, Field and Laboratory Infrared Spectrophotometer, and Raman Spectrometer Based Analyzer Systems