• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM D 8165 : 2017

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Standard Test Method for Evaluation of Load-Carrying Capacity of Lubricants Used in Hypoid Final-Drive Axles Operated under Low-Speed and High-Torque Conditions
Available format(s)

Hardcopy , PDF

Superseded date

26-07-2019

Language(s)

English

Published date

01-12-2017

CONTAINED IN VOL. 05.05, 2018 Specifies a test procedure for evaluating the load-carrying capacity, wear performance, and extreme pressure properties of a gear lubricant in a hypoid axle under conditions of lowspeed, high-torque operation.

1.1This test method, commonly referred to as the L-37-1 test, describes a test procedure for evaluating the load-carrying capacity, wear performance, and extreme pressure properties of a gear lubricant in a hypoid axle under conditions of low-speed, high-torque operation.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1Exceptions—Where there is no direct SI equivalent such as National Pipe threads/diameters, tubing size, or where there is a sole source supply equipment specification.

1.2.1.1The drawing in Annex A6 is in inch-pound units.

1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are provided in 7.2 and 10.1.

1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee
D 02
DocumentType
Test Method
Pages
18
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy

ASTM D 7450 : 2019 Standard Specification for Performance of Rear Axle Gear Lubricants Intended for API Category GL-5 Service

AGMA 1010 : E APPEARANCE OF GEAR TEETH - TERMINOLOGY OF WEAR AND FAILURE
API 1560 : 1995 LUBRICANT SERVICE DESIGNATIONS FOR AUTOMOTIVE MANUAL TRANSMISSIONS, MANUAL TRANSAXLES, AND AXLES
ASTM D 6121 : 2017 : REDLINE TEST METHOD FOR EVALUATION OF LOAD-CARRYING CAPACITY OF LUBRICANTS UNDER CONDITIONS OF LOW SPEED AND HIGH TORQUE USED FOR FINAL HYPOID DRIVE AXLES
SAE J 308 : 2007 AXLE AND MANUAL TRANSMISSION LUBRICANTS
SAE J 2360 : 2012 AUTOMOTIVE GEAR LUBRICANTS FOR COMMERCIAL AND MILITARY USE

View more information
£69.29
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.