• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

ASTM E 1925 : 2010

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures
Available format(s)

Hardcopy , PDF

Superseded date

16-11-2018

Language(s)

English

Published date

01-10-2010

This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and nonexpandable RWRSs.

1.1 This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and nonexpandable RWRSs. This specification applies to present engineering and design requirements for effective RWRSs that are operable in a variety of environments without degradation and are capable of all specified transport modes. This specification shall be applied to the design of expandable and nonexpandable RWRSs. This specification is a conversion of a military standard that was approved by all departments and agencies of the Department of Defense.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test required portion, Section 10, of this specification. This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Committee
E 06
DocumentType
Standard
Pages
13
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

ASTM E 631 : 2015 Standard Terminology of Building Constructions
ASTM E 1975 : 2018 Standard Specification for Shelter, Electrical, Equipment S-280/G
ASTM E 2517 : 2013 Standard Specification for Cargo Bed Cover, Type III (M35A2, 2 1/2 Ton Cargo Truck/M1078, 2 1/2 Ton Lightweight Medium Tactical Vehicle (LMTV)/ M1082, 2 1/2 Ton LMTV Trailer)
ASTM E 1749 : 2018 Standard Terminology Relating to Rigid Wall Relocatable Shelters
ASTM E 2377 : 2018 Standard Specification for Shelter, Electrical Equipment, Lightweight
ASTM E 1977 : 2018 Standard Specification for Shelter, Tactical, Expandable, One-Side
ASTM E 2462 : 2018 Standard Performance Specification for Cargo Bed Cover (CBC) HMMWV, Type I
ASTM E 1978 : 2018 Standard Specification for Shelter, Tactical, Expandable, Two-Side

View more information
£69.29
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.