Standard Test Method for Temperature Calibration of Differential Scanning Calorimeters and Differential Thermal Analyzers

Available format(s)

PDF

Language(s)

English

Published date

20-03-2018

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 14.02, 2018 Specifies the temperature calibration of differential thermal analyzers and differential scanning calorimeters over the temperature range from -40 to +2500 degrees C.

1.1This test method describes the temperature calibration of differential thermal analyzers and differential scanning calorimeters over the temperature range from −40°C to +2000°C.

1.2The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3This test method is similar to ISO standard 11357–1.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 7.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	E 37
DocumentType	Redline
Pages	6
PublisherName	American Society for Testing and Materials
Status	Current

ASTM E 1142 : 2015 : REDLINE	Standard Terminology Relating to Thermophysical Properties
ASTM E 473 : 2016-05	TERMINOLOGY RELATING TO THERMAL ANALYSIS AND RHEOLOGY
ISO 11357-1:2016	Plastics — Differential scanning calorimetry (DSC) — Part 1: General principles