Standard Practice for Rehabilitation of Existing Sewers and Conduits with Deformed Polyethylene (PE) Liner

Available format(s)

Hardcopy , PDF

Language(s)

English

Published date

16-12-2019

Publisher

American Society for Testing and Materials

1.1This practice covers the requirements for the installation of deformed polyethylene (PE) liner for pipeline rehabilitation.

1.2This practice describes a method by which the PE liner may be installed with little or no excavation.

1.3This practice applies to the rehabilitation of 3 to 18 in. (76 to 457 mm) diameter pipe in terms of installation. The specifier determines what DR is used based on conditions of the specific application.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Committee	F 17
DocumentType	Standard Practice
Pages	6
PublisherName	American Society for Testing and Materials
Status	Current
Supersedes	ASTM F 1606 : 2005 : R2014

ASTM F 2896 : 2011 : R2017	Standard Specification for Reinforced Polyethylene Composite Pipe For The Transport Of Oil And Gas And Hazardous Liquids
ASTM F 3508 : 2021	Standard Guide for In-Situ Pipeline Re-Construction As Coupled Dual-Wall Composite Pipeline by Push/Pull Installation of Compressed-Fit Shape-Memory-Polymer Tubular (SMPT)

ASTM F 412 : 2020 : REV A	Standard Terminology Relating to Plastic Piping Systems
ASTM F 412 : 2021	Standard Terminology Relating to Plastic Piping Systems
ASTM D 3350 : 2021	Standard Specification for Polyethylene Plastics Pipe and Fittings Materials
ASTM D 3350 : 2014	Standard Specification for Polyethylene Plastics Pipe and Fittings Materials
ASTM F 1417 : 2011 : REV A : R2019 : EDT 1	Standard Practice for Installation Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure Air
ASTM D 638 : 2014	Standard Test Method for Tensile Properties of Plastics
ASTM D 2122 : 2022	Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
ASTM D 1600 : 2018	Standard Terminology for Abbreviated Terms Relating to Plastics (Withdrawn 2024)
ASTM F 412 : 2023	Standard Terminology Relating to Plastic Piping Systems
ASTM D 2122 : 2016	Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
ASTM F 1533 : 2020	Standard Specification for Deformed Polyethylene (PE) Liner
ASTM F 1533 : 2001 : R2009	Standard Specification for Deformed Polyethylene (PE) Liner (Withdrawn 2018)
ASTM F 1417 : 2011 : REV A : R2019	Standard Practice for Installation Acceptance of Plastic Non-pressure Sewer Lines Using Low-Pressure Air
ASTM D 638 : 2022	Standard Test Method for Tensile Properties of Plastics