We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • ASTM F 2754/F2754M : 2009 : R2013

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    Standard Test Method for Measurement of Camber, Cast, Helix and Direction of Helix of Coiled Wire

    Available format(s):  Hardcopy, PDF

    Superseded date:  05-11-2021

    Language(s):  English

    Published date:  07-11-2013

    Publisher:  American Society for Testing and Materials

    Add to Watchlist

    Add To Cart

    Abstract - (Show below) - (Hide below)

    CONTAINED IN VOL. 13.01, 2015 Describes the various standard methods that are used for measuring camber, cast, helix, and helix direction. The wire may be coiled with or without a spool.

    Scope - (Show below) - (Hide below)

    1.1This test method covers the various standard methods that are used for measuring camber, cast, helix, and helix direction. The wire may be coiled with or without a spool.

    1.2This test method applies to round wire that has a diameter between 0.0127 to 4.78 mm (0.0005 to 0.188 in.). It also applies to flat or shaped wire.

    1.3This test method does not apply to superelastic nitinol wire. It does apply to the as-drawn condition of nitinol wire.

    1.4This test method does not apply to the measurement of the straightness of straightened to length wire and tubing.

    1.5The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

    1.6This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    General Product Information - (Show below) - (Hide below)

    Committee F 04
    Document Type Test Method
    Product Note Reconfirmed 2013
    Publisher American Society for Testing and Materials
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    ASTM F 2819 : 2010 : R2015 : EDT 2 Standard Test Methods for Measurement of Straightness of Bar, Rod, Tubing and Wire to be used for Medical Devices
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective