Standard Guide for Insertion of Flexible Polyethylene Pipe Into Existing Sewers

Available format(s)

PDF

Language(s)

English

Published date

01-10-2016

Publisher

American Society for Testing and Materials

CONTAINED IN VOL. 08.04, 2018 Specifies design and selection considerations and installation procedures for the rehabilitation of sanitary and storm sewers by the insertion of solid wall or profile wall or corrugated polyethylene pipe into an existing pipe and along its existing line and grade.

1.1This guide describes design and selection considerations and installation procedures for the rehabilitation of sanitary and storm sewers by the insertion of solid wall or profile wall or corrugated polyethylene pipe into an existing pipe and along its existing line and grade. The procedures in this guide are intended to minimize traffic disruption, surface damage, surface restoration and interruption of service.

1.2The polyethylene piping product manufacturer should be consulted to determine the polyethylene piping product’s suitability for insertion renewal as described in this guide.

1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 6.1, 7.1, and 8.1 for additional safety precautions.

Committee	F 17
DocumentType	Redline
Pages	10
PublisherName	American Society for Testing and Materials
Status	Current

ASTM F 714 : 2013 : REDLINE	Standard Specification for Polyethylene (PE) Plastic Pipe (DR-PR) Based on Outside Diameter
ASTM F 2896 : 2011 : R2017	Standard Specification for Reinforced Polyethylene Composite Pipe For The Transport Of Oil And Gas And Hazardous Liquids
AASHTO M 326 : 2008	SPECIFICATION FOR POLYETHYLENE (PE) LINER PIPE, 300- TO 1600-MM DIAMETER, BASED ON CONTROLLED OUTSIDE DIAMETER
ASTM F 2896 : 2011	Standard Specification for Reinforced Polyethylene Composite Pipe For The Transport Of Oil And Gas And Hazardous Liquids