AWS A5.2 : 92(R1997)

Personnel
Foreword
1 Scope
Part A - General requirements
2 Classification
3 Acceptance
4 Certification
5 Units of measure and rounding-off procedure
Part B - Test, procedures, and requirements
6 Summary of tests
7 Retest
8 Weld test assembly
9 Chemical analysis
10 Tension test
Part C - Manufacture, identification, and packaging
11 Method of manufacture
12 Standard sizes and lengths
13 Finish and uniformity
14 Filler metal identification
15 Packaging
16 Marking of packages
Appendix - Guide to AWS specification for carbon and low
           alloy steel rods for oxyfuel gas welding
A1 Introduction
A2 Classification system
A3 Acceptance
A4 Certification
A5 Ventilation during welding
A6 Welding considerations
A7 Description and intended use of carbon and low alloy
    steel rods
A8 Special tests
A9 Discontinued classifications
Tables
1 Tension test requirements
2 Required tests
3 Base metal required for test assemblies
4 Chemical composition requirements for welding rods
    and rod stock
5 Standard filler metal sizes
A1 Discontinued classifications
Figures
1 Groove weld test assembly for mechanical properties
2 Tension test specimen
AWS filler metal specifications and related documents

92 VERSION CONTAINED IN ASME PV CODE 2C AS SFA-5.2 Prescribes the requirements for classification of carbon and low alloy steel rods for oxyfuel gas welding. The requirements include chemical composition of the rod and mechanical properties of the weld metal as well as requirements for manufacture, identification, and packaging. A guide is appended to the specification as a source of information concerning the classification system employed and the intended use of the rods.