• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

BS 3549-2:1981

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Methods of measuring and expressing the performance of television receivers Electrical and acoustic measurements at audio-frequencies
Available format(s)

Hardcopy , PDF

Superseded date

15-12-1997

Language(s)

English

Published date

31-07-1981

National foreword
Cooperating organizations
Chapter I: General
1. Introduction
Chapter II: General notes on measurements
2. General conditions
3. Audio-frequency input signal
4. Audio-frequency output power
Chapter III: Acoustic measurements
5. Acoustic frequency response characteristic
6. Acoustic polar diagram
Chapter IV: Electrical response measurements
7. Electrical audio-frequency response characteristic
8. Electrical audio-frequency response characteristics
     of tone controls
9. Electrical audio-frequency response characteristics
     of loudness controls
10. Volume control characteristic
Chaper V: Audio-frequency non-linearity distortion
11. General
12. Distortion in the presence of a single signal,
     harmonic distortion
13. Distortion in the presence of two simultaneous
     signals (intermodulation)
Chapter VI: Internally generated interference
14. Signal-to-noise ratio due to picture signal cross-
     modulation
15. Amplitude modulation suppression ratio
16. Amplitude modulated sound reception signal-to-noise
     ratio due to picture signal interference
17. Hum
Chapter VII: Sensitivity
18. Signal-to-noise ratio
19. Noise limited sensitivity
20. Gain limited sensitivity
21. Deviation sensitivity
22. Distortion-limited deviation sensitivity

Gives recommended methods of measurement for assessing the performance of the sound section of monochrome and colour television receivers.

Committee
EPL/100
DocumentType
Standard
Pages
24
PublisherName
British Standards Institution
Status
Superseded
SupersededBy

BS EN 61079-5:1995 Methods of measurement on receivers for satellite broadcast transmissions in the 12 GHz band Electrical measurements on decoder units for MAC/packet systems
BS 7429:1991 Specification for television receivers and monitors for use in education and training
BS 5942-12:1989 High fidelity audio equipment and systems; minimum performance requirements Specification for the sound output of television tuners
BS 4054(1966) : 1966 METHODS FOR MEASURING AND EXPRESSING THE PERFORMANCE OF RADIO RECEIVERS - RECEIVERS FOR A.M. AND F.M. SOUND BROADCAST TRANSMISSIONS

IEC 60107-1:1997 Methods of measurement on receivers for television broadcast transmissions - Part 1: General considerations - Measurements at radio and video frequencies
ISO 266:1997 Acoustics — Preferred frequencies
IEC 60268-14:1980 Sound system equipment. Part 14: Circular and ellipticalloudspeakers; outer frame diameters and mounting dimensions
IEC 60107-4:1988+AMD1:1999 CSV Recommended methods of measurement on receivers for television broadcast transmissions - Part 4: Electrical measurements on multichannel sound television receivers using the two-carrier FM-system
IEC 60268-5:2003+AMD1:2007 CSV Sound system equipment - Part 5: Loudspeakers

View more information
£198.00
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.