BS EN 1295-1 : 1998
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
22-04-2019
English
01-01-1998
Foreword
Introduction
1 Scope
2 Normative references
3 Definitions
3.1 Installation terms
3.2 Design terms
4 Requirements
5 Basis of design procedures
5.1 General
5.2 External loads
5.3 Limit states
5.4 Longitudinal effects
6 Additional considerations for pressure pipelines
6.1 General
6.2 Stresses and strains resulting from simultaneous
loads
6.3 Effect of pressure on deformation
6.4 Buckling of pressure pipes
6.5 Thrusts and longitudinal stresses
7 Influence of construction procedures
7.1 General
7.2 Trenching procedures
7.3 Pipe bedding
7.4 Filling procedures
8 Design philosophies and factors of safety
Annexes
A (informative) - Pipe definition according to
cross-sectional behaviour
B (informative) - Nationally established methods of
design
B.1 Identification of methods and addresses where they
are available
B.1.1 Austria
B.1.2 Belgium
B.1.3 Denmark
B.1.4 Finland
B.1.5 France
B.1.6 Germany
B.1.7 Netherlands
B.1.8 Norway
B.1.9 Spain
B.1.10 Sweden
B.1.11 Switzerland
B.1.12 United Kingdom
B.2 Description of methods
B.2.1 Austria
B.2.2 Belgium
B.2.3 Denmark
B.2.4 Finland
B.2.5 France
B.2.6 Germany
B.2.7 Netherlands
B.2.8 Norway
B.2.9 Spain
B.2.10 Sweden
B.2.11 Switzerland
B.2.12 United Kingdom
National annex A (informative) - Calculation procedure for
UK established method
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.