1 Scope
2 Normative references
3 Definitions
4 General conditions of measurement and operation
5 General performance characteristics
      5.1 Transmission systems
      5.2 Frequency (range, stability, etc)
      5.3 Output power
      5.4 Power consumption
      5.5 Impedance
      5.6 Bandwidth
      5.7 Out-of-band emission
      5.8 Spurious emission
      5.9 Cabinet radiation
6 Protection against atmospheric discharge
      6.1 General
      6.2 Methods of measurement
7 Acoustic noise produced by the transmitter system
      7.1 Definition
      7.2 General
      7.3 Measurements
Annex A (informative) Acoustic noise in transmitter halls
Annex B (informative) Protection against atmospheric
                      discharge
Annex C (normative) Transmitter frequency tolerances
Annex D (normative) Permitted spurious emission power levels
Annex E (informative) Bibliography
Annex ZA (normative) Normative references to international
                     publications with their corresponding
                     European publications
Figure 1 - Example of frequency drift as a function of
           time f(t)
Figure 2 - Typical pulse generator output voltage
           characteristic
Figure 3 - Example of a block diagram for the pulse generator
Figure A.1 - Acoustic noise rating nomogram
Figure B.1 - Test bench for measurement of protection against
             impulses of magnitude 1,2/50 of the 6 kV peak
             value
Figure B.2 - Test bench for measurement of protection against
             impulses of magnitude 1,2/50 of the 6 kV peak
             value
Figure B.3 - Correction factor for air density
Figure B.4 - Voltage waveform of an ideal impulse
Figure B.5 - Examples of curves for the determination of the
             ideal peak value
Figure B.6 - Examples of irregular waveforms