This document specifies the general aspects of polyethylene (PE) compounds for the manufacture of pressure pipes and fittings (mains and service pipes) for buried or above ground applications, intended for the conveyance of:
-
water for human consumption;
-
raw water prior to treatment;
-
drainage and sewerage under pressure;
-
vacuum sewer systems;
-
water for other purposes.
This document also specifies the test parameters and requirements for the test methods referred to in this document.
In conjunction with other parts of the ISO4427series, this document is applicable to PE pipes and fittings, their joints and to joints with components made of PE and other materials, intended to be used under the following conditions:
-
a maximum allowable operating pressure (PFA) up to and including 25bar 1
1
1bar=0,1MPa=10 5Pa; 1MPa=1N/mm 2.
;
-
an operating temperature of 20C as the reference temperature.
NOTE1
For other operating temperatures, guidance is given in AnnexA.
The ISO4427series covers a range of maximum allowable operating pressures and gives requirements concerning colours.
NOTE2
It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and installation practices or codes.