• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

BS ISO 8529-1:2001

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Reference neutron radiations Characteristics and methods of production
Available format(s)

Hardcopy , PDF

Superseded date

10-12-2021

Language(s)

English

Published date

28-08-2001

Foreword
Introduction
1 Scope
2 Normative references
3 Tests and definitions
4 Reference radiations for the calibration of
      neutron-measuring devices
5 Reference radiations for the determination
      of neutron-measuring devices as a function
      of neutron energy
Annex A (normative) Tabular and graphical
        representation of the neutron spectra for
        radionuclide sources
Annex B (informative) Angular source strength
        characteristics of two radionuclide neutron
        sources
Annex C (normative) Conventional thermal-neutron
        fluence rate
Bibliography

This part describes the reference neutron radiations, in the energy range from thermal up to 20 MeV, for calibrating neutron-measuring devices used for radiation protection purposes and for determining their response as a function of neutron energy. Also provides the methods of producing and characterizing the neutron reference radiations.

This part of ISO8529 specifies the reference neutron radiations, in the energy range from thermal up to 20 MeV, for calibrating neutron-measuring devices used for radiation protection purposes and for determining their response as a function of neutron energy. Reference radiations are given for neutron fluence rates of up to 1×109 m−2·s−1, corresponding, at a neutron energy of 1 MeV, to dose-equivalent rates of up to 100mSv·h−1.

This part of ISO8529 is concerned only with the methods of producing and characterizing the neutron reference radiations. The procedures for applying these radiations for calibrations are described in ISO8529-2 and ISO8529-3.

The reference radiations specified are the following:

  • neutrons from radionuclide sources, including neutrons from sources in a moderator;

  • neutrons produced by nuclear reactions with charged particles from accelerators;

  • neutrons from reactors.

In view of the methods of production and use of them, these reference radiations are divided, for the purposes of this part of ISO8529, into the following two separate sections.

  • In clause4, radionuclide neutron sources with wide spectra are specified for the calibration of neutron-measuring devices. These sources should be used by laboratories engaged in the routine calibration of neutron-measuring devices, the particular design of which has already been type tested.

  • In clause5, accelerator-produced monoenergetic neutrons and reactor-produced neutrons with wide or quasi monoenergetic spectra are specified for determining the response of neutron-measuring devices as a function of neutron energy. Since these reference radiations are produced at specialized and well equipped laboratories, only the minimum of experimental detail is given.

For the conversion of neutron fluence into the quantities recommended for radiation protection purposes, conversion coefficients have been calculated based on the spectra presented in normative annexA and using the fluence-to-dose-equivalent conversion coefficients as a function of neutron energy as given in ICRP Publication 74 and ICRU Report 57.

Committee
NCE/2
DevelopmentNote
Supersedes 99/711965 DC. (06/2005) Reviewed and confirmed by BSI, April 2012. (04/2012)
DocumentType
Standard
Pages
34
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
ISO 8529-1:2001 Identical

ISO 8529-3:1998 Reference neutron radiations — Part 3: Calibration of area and personal dosimeters and determination of response as a function of energy and angle of incidence
ISO 8529-2:2000 Reference neutron radiations Part 2: Calibration fundamentals of radiation protection devices related to the basic quantities characterizing the radiation field

View more information
£232.00
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.