CSA CEI/IEC 61000.4.6 : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4: TESTING AND MEASUREMENT TECHNIQUES - SECTION 6: IMMUNITY TO CONDUCTED DISTURBANCES, INDUCED BY RADIO-FREQUENCY FIELDS
Hardcopy , PDF
01-07-2009
English
FOREWORD
INTRODUCTION
1. Scope
2. Normative references
3. General
4. Definitions
5. Test levels
6. Test equipment
6.1 Test generator
6.2 Coupling and decoupling devices
6.3 Verification of the common-mode impedance at the
EUT port of coupling and decoupling devices
6.4 Setting of the test generator
7. Test set-up for table-top and floor-standing equipment
7.1 Rules for selecting injection methods and test points
7.2 Procedure for clamp injection application
7.3 Procedure for clamp injection when the common-mode
impedance requirements cannot be met
7.4 EUT comprising a single unit
7.5 EUT comprising several units
8. Test procedure
9. Test results and test report
Annexes
A Additional information regarding clamp injection
B Selection criteria for the frequency range of application
C Guide for selecting test levels
D Information on coupling and decoupling networks
E Information for the test generator specification
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.