EIA 5200000 : D2000

INTRODUCTION
1.0 Scope and Objective
1.1 Scope
1.2 Objective
2.0 General
2.1 Related Documents
2.2 Units and Symbols
2.3 Terminology
2.4 Marking
3.0 Quality Assessment Procedures
3.1 Qualification Approval Procedures
3.2 Primary Stage of Manufacture
3.3 Structurally Similar Switches
3.4 Quality Conformance Inspection
3.5 Alternative Test Methods
3.6 Unchecked Parameters
4.0 Test and Measurement Procedures
4.1 General
4.2 Standard Atmospheric Conditions
4.3 Standard Drying Conditions
4.4 Test 1: General Examinations
4.5 Test 2: Resistance Measurements
4.6 Test 3: Voltage Stress
4.7 Test 4: Temperature Rise
4.8 Test 5: Dynamic Stress
4.9 Test 6: Mechanical Strength
4.10 Test 7: Endurance
4.11 Test 8: Electrical Endurance
4.12 Test 9: Overload
4.13 Test 10: Environmental
4.14 Test 11: Soldering
4.15 Test 13: Panel Seal
4.16 Test 14: Sealing
4.17 Test 15: Resistance to Fluids
4.18 Test 16: Fire Hazard
4.19 Test 17: Capacitance
4.20 Test 18: Illumination
Appendix A - Terminology
Appendix B - Qualification Approval Test Schedule
Appendix C - Quality Conformance Inspection

This specification was formulated for the purpose of providing a document setting engineering and application requirements as necessary for optimum use of special-use electromechanical switches of certified quality. Utilization of this document is intended to eliminate misunderstandings or confusion between the manufacturer and buyer with respect to product performance requirements and test procedures.