This European Standard specifies the characteristics of the fitness for purpose of the assembled piping systemsintended for the conveyance of water intended for human consumption, raw water prior to treatment, drainage andsewerage under pressure, vacuum sewer systems, and water for other purposes.It also specifies the method of preparation of test piece joints, and the tests to be carried out on these joints forassessing the fitness for purpose of the system under normal and extreme conditions.NOTE 1 For PE components intended for the conveyance of water for human consumption and raw water prior to treatmentattention is drawn to the introduction of this part of EN 12201. Components manufactured for water for other purposes may notbe suitable for water supply for human consumption.It also specifies the test parameters for the test methods referred to in this standard.In conjunction with Parts 1 to 4 of EN 12201 it is applicable to PE pipes, fittings, valves, their joints and to jointswith components of other materials intended to be used under the following conditions:a) allowable operating pressure, PFA, up to 25 bar 1) ;b) an operating temperature of 20 °C as a reference temperature.c) buried in the ground;d) sea outfalls;e) laid in water;f) above ground, including pipes suspended below bridges.NOTE 2 For applications operating at constant temperatures greater than 20 °C up to 40 °C, see Annex A ofEN 12201-1:2011.EN 12201 (all parts) covers a range of allowable operating pressures and gives requirements concerning coloursand additives.NOTE 3 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking intoaccount their particular requirements and any relevant national guidance or regulations and installation practices or codes.