EN 1653:1997/A1:2000

Foreword
1 Scope
2 Normative references
3 Definitions
   3.1 Plate
   3.2 Sheet
   3.3 Circle
4 Designations
   4.1 Material
   4.2 Material condition
   4.3 Product
5 Ordering information
6 Requirements
   6.1 Plate, sheet and circles for boilers, pressure
        vessels and heat exchangers
   6.2 Sheet and circles for hot water storage units
7 Sampling
   7.1 General
   7.2 Analysis
   7.3 Tensile, hardness and bend tests
8 Test methods
   8.1 Analysis
   8.2 Tensile test
   8.3 Hardness test
   8.4 Bend test
   8.5 Retests
   8.6 Rounding of results
9 Declaration of conformity and inspection documentation
   9.1 Declaration of conformity
   9.2 Inspection documentation
10 Marking, packaging, labelling
Annex A (informative) Bibliography
Annex B (informative) Mechanical properties at elevated
temperatures for boilers, pressure vessels and heat exchangers
Annex ZA (informative) Clauses of this European Standard
         addressing essential requirements or other provisions
         of EU Directives
Table 1 Composition of copper
Table 2 Composition of copper alloys
Table 3 Mechanical properties of plate, sheet and circles
          for boilers, pressure vessels and heat
          exchangers
Table 4 Tolerances on thickness of plate, sheet and
          circles for boilers, pressure vessels and heat
          exchangers
Table 5 Tolerances on width and length of plate and sheet
          for boilers, pressure vessels and heat exchangers
Table 6 Squareness of plate and sheet for boilers,
          pressure vessels and heat exchangers
Table 7 Tolerances on diameter of circles for boilers,
          pressure vessels and heat exchangers
Table 8 Tolerances on flatness of plates for boilers,
          pressure vessels and heat exchangers
Table 9 Vickers hardness for sheet and circles for
          hot water storage units
Table 10 Tolerances on thickness and width, length or
          diameter of sheet and circles for hot water
          storage units