EN 50091-1-2 : 98 COR 1 99
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
16-01-2003
12-01-2013
1 General
1.1 Scope
1.2 Normative references
1.3 Definitions
1.4 General requirements
1.5 General conditions for tests
1.6 Components
1.7 Power interfaces
1.8 Marking and instructions
2 Fundamental design requirements
2.1 Protection against electric shock and energy hazards
2.2 Insulation
2.3 Safety Extra-Low Voltage (SELV) Circuits
2.4 Limited current circuits
2.5 Provisions for protective earthing
2.6 A.C. and d.c. power isolation
2.7 Overcurrent and earth fault protection
2.8 Protection of service personnel
2.9 Clearances, creepage distances and distances through
insulation
2.10 External signalling circuits
2.11 Limited power source
2.12 Protection of the applied load
2.13 Connection to other equipment
3 Wiring, connections and supply
3.1 General
3.2 Connection to power sources
3.3 Wiring terminals for external power conductors
4 Physical requirements
4.1 Stability and mechanical hazards
4.2 Mechanical strenght and stress relief
4.3 Construction details
4.4 Resistance to fire
4.5 Battery location
5 Thermal and electrical requirements
5.1 Heating
5.2 Earth leakage current
5.3 Electric strength
5.4 Abnormal operating and fault conditions
Annex A (normative) Test for resistance to heat and fire
Annex B (normative) Motor test under abnormal conditions
Annex C (normative) Transformers
Annex D (normative) Measuring instruments for earth
leakage current test
Annex E (normative) Temperature rise of a winding
Annex F (normative) Measurements of creepage
Annex G (normative) Earth leakage current for UPS intended
to be connected directly to IT power systems
Annex H (informative) Guidance on protection against ingress
of water and foreign objects
Annex J (informative) Tables of electrochemical potentials
Annex K (normative) Thermal controls
Annex L (normative) Backfeed protection test
Annex M (normative) Reference load conditions
Annex N (normative) Ventilation of battery compartments
Annex P (normative) Minimum and maximum cross-sections
for copper conductor
Annex Q (informative) A-Deviations
Annex R (normative) Special national conditions
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.