EN 61347-2-7:2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
26-11-2019
02-03-2012
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for protective earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings of ballasts
14 Fault conditions
15 Starting conditions
16 Lamp current
17 Supply current
18 Maximum current in any lead (with cathode preheating)
19 Lamp operating current waveforms
20 Functional safety (EBLF)
21 Changeover operation
22 Recharging device
23 Protection against excessive discharge
24 Indicator
25 Remote control, rest mode, inhibition mode
26 Temperature cycling test and endurance test
27 Polarity reversal
28 Fault conditions
29 Construction
30 Creepage distances and clearances
31 Screws, current-carrying parts and connections
32 Resistance to heat, fire and tracking
33 Resistance to corrosion
34 Abnormal lamp conditions
35 Protection of associated components
Annex A (normative) - Test to establish whether a conductive
part is a live part, which may cause an electric shock
Annex B (normative) - Particular requirements for thermally
protected lamp controlgear
Annex C (normative) - Particular requirements for electronic
lamp control gear with means of protection against
overheating
Annex D (normative) - Requirements for carrying out the
heating test of thermally protected lamp control gear
Annex E (normative) - Use of constant S other than 4500 in
t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation of the
values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Batteries for emergency lighting
luminaries
Annex J (informative) - Rest mode and inhibition mode
facilities
Annex K (normative) - Ballasts incorporating an automatic
testing function for emergency lighting operation
Annex L (informative) - Compatibility between normal mains
operation Electronic control gear and battery-powered
emergency operation control gear
Annex ZA (normative) - Normative references to
international publications with their corresponding
European publications
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.