• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

EN ISO 22475-1:2006

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

Geotechnical investigation and testing - Sampling methods and groundwater measurements - Part 1: Technical principles for execution (ISO 22475-1:2006)
Superseded date

01-11-2021

Published date

15-09-2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
   3.1 Site investigation methods
   3.2 Drilling rigs and equipment
   3.3 Sampling
   3.4 Groundwater measurements
4 Drilling rigs and ancillary equipment
   4.1 General
   4.2 Requirements for the drilling rigs and equipment
   4.3 Equipment scope
5 General requirements prior to sampling and groundwater
   measurements
   5.1 General
   5.2 Selection of techniques and methods
   5.3 Requirements for ground investigation sites and
        points
   5.4 Preliminary information needed before starting
        sampling and groundwater measurements
   5.5 Backfilling and site abandonment
   5.6 Safety and special requirements
6 Soil sampling methods
   6.1 General
   6.2 Categories of soil sampling methods
   6.3 Sampling by drilling (continuous sampling)
   6.4 Sampling using samplers
   6.5 Block sampling
7 Rock sampling methods
   7.1 General
   7.2 Categories for rock sampling methods
   7.3 Sampling by drilling
   7.4 Block sampling
   7.5 Integral sampling
8 Groundwater sampling methods for geotechnical purposes
   8.1 General
   8.2 Equipment
   8.3 Techniques of groundwater sampling
9 Groundwater measuring stations and piezometers
   9.1 General
   9.2 Piezometers
   9.3 Installation of piezometers
   9.4 Maintenance
   9.5 Decommissioning
10 Groundwater measurements
   10.1 Calibration
   10.2 Performance of the measurements
11 Handling, transport and storage of samples
   11.1 General
   11.2 Preservation materials and sample containers
   11.3 Handling of samples
   11.4 Labelling of samples
   11.5 Transport of samples
   11.6 Preparation of storage and shipping containers
   11.7 Storage of samples
12 Report
   12.1 Field report
   12.2 Report of the results
Annex A (informative) Example of a form for the preliminary
        information on the intended sampling and groundwater
        measurements
Annex B (informative) Field reports
Annex C (informative) Drilling and sampling equipment for
        soil and rock
Annex D (informative) Vacuum bottles for groundwater sampling
Annex E (informative) Protective measures of piezometers
Bibliography

ISO 22475-1:2006 deals with the technical principles of sampling soil, rock and groundwater, and with groundwater measurements, in the context of geotechnical investigation and testing, as described in EN 1997-1 and EN 1997-2.

Committee
CEN/TC 341
DocumentType
Standard
PublisherName
Comite Europeen de Normalisation
Status
Superseded
SupersededBy

05/30123732 DC : DRAFT JUN 2005 EN ISO 22476-4 - GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 4: MENARD PRESSUREMETER TEST
CEN/TR 16365:2012 Characterization of waste - Sampling of waste from extractive industries
16/30342037 DC : 0 BS EN 13941-1 - DISTRICT HEATING PIPES - DESIGN AND INSTALLATION OF THERMAL INSULATED BONDED SINGLE AND TWIN PIPE SYSTEMS FOR DIRECTLY BURIED HOT WATER NETWORKS - PART 1: DESIGN
16/30331264 DC : 0 BS EN WI 22476-10 - GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 10: WEIGHT SOUNDING TEST
I.S. EN 16502:2014 TEST METHOD FOR THE DETERMINATION OF THE DEGREE OF SOIL ACIDITY ACCORDING TO BAUMANN-GULLY
PD CEN/TR 16365:2012 Characterization of waste. Sampling of waste from extractive industries
I.S. EN 50119:2009 RAILWAY APPLICATIONS - FIXED INSTALLATIONS - ELECTRIC TRACTION OVERHEAD CONTACT LINES
VDI 4085 Blatt 2:2015-12 Scrap yards - Baseline report
02/105585 DC : DRAFT SEP 2002 PREN ISO 22476-3 - GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 3: STANDARD PENETRATION TEST
08/30123709 DC : DRAFT APR 2008 ISO 22282-2 - GEOTECHNICAL INVESTIGATION AND TESTING - GEOHYDRAULIC TESTING - PART 2: WATER PERMEABILITY TESTS IN A BOREHOLE
DIN 4030-2:2008-06 ASSESSMENT OF WATER, SOIL AND GASES FOR THEIR AGGRESSIVENESS TO CONCRETE - PART 2: SAMPLING AND ANALYSIS OF WATER AND SOIL SAMPLES
07/30123721 DC : DRAFT DEC 2007 BS ISO 22282-4 - GEOTECHNICAL INVESTIGATION AND TESTING - GEOHYDRAULIC TESTING - PART 4: PUMPING TESTS
07/30123718 DC : DRAFT DEC 2007 BS ISO 22282-5 - GEOTECHNICAL INVESTIGATION AND TESTING - GEOHYDRAULIC TESTING - PART 5: INFILTROMETER TEST
14/30292494 DC : 0 BS EN ISO 22476-15 - GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 15: MEASURING WHILE DRILLING
S.R. CEN/TR 16365:2012 CHARACTERIZATION OF WASTE - SAMPLING OF WASTE FROM EXTRACTIVE INDUSTRIES
UNI EN ISO 22476-3 : 2012 GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 3: STANDARD PENETRATION TEST
UNI EN 1997-2 : 2007 EUROCODE 7 - GEOTECHNICAL DESIGN - PART 2: GROUND INVESTIGATION AND TESTING
UNI EN 16502 : 2014 TEST METHOD FOR THE DETERMINATION OF THE DEGREE OF SOIL ACIDITY ACCORDING TO BAUMANN-GULLY
14/30292497 DC : 0 BS EN ISO 22476-9 - GROUND INVESTIGATION AND TESTING - FIELD TESTING - PART 9: FIELD VANE TEST
05/30123744 DC : DRAFT JUN 2005 EN ISO 22476-7 - GEOTECHNICAL INVESTIGATION AND TESTING - FIELD TESTING - PART 7: BOREHOLE JACK TEST
I.S. EN 1997-2:2007 EUROCODE 7 - GEOTECHNICAL DESIGN - PART 2: GROUND INVESTIGATION AND TESTING
BS EN 50119 : 2009 RAILWAY APPLICATIONS - FIXED INSTALLATIONS - ELECTRIC TRACTION OVERHEAD CONTACT LINES
DIN EN 16502 E : 2014 TEST METHOD FOR THE DETERMINATION OF THE DEGREE OF SOIL ACIDITY ACCORDING TO BAUMANN-GULLY
12/30270967 DC : 0 BS EN 16502 - TEST METHOD FOR THE DETERMINATION OF THE DEGREE OF SOIL ACIDITY ACCORDING TO BAUMANN-GULLY
15/30326284 DC : 0 BS EN 16907-2 - EARTHWORKS - PART 2: CLASSIFICATION OF MATERIALS
DIN EN 1997-2:2010-10 Eurocode 7: Geotechnical design - Part 2: Ground investigation and testing (includes Corrigendum AC:2010)
BS EN 16502:2014 Test method for the determination of the degree of soil acidity according to Baumann-Gully
I.S. EN 50119:2020 Railway applications - Fixed installations - Electric traction overhead contact lines
EN 50119 : 2009 AMD 1 2013 RAILWAY APPLICATIONS - FIXED INSTALLATIONS - ELECTRIC TRACTION OVERHEAD CONTACT LINES
DIN EN 16502:2014-11 TEST METHOD FOR THE DETERMINATION OF THE DEGREE OF SOIL ACIDITY ACCORDING TO BAUMANN-GULLY
EN 16502:2014 Test method for the determination of the degree of soil acidity according to Baumann-Gully
EN 1997-2:2007/AC:2010 EUROCODE 7 - GEOTECHNICAL DESIGN - PART 2: GROUND INVESTIGATION AND TESTING
BS EN 1997-2:2007 Eurocode 7. Geotechnical design Ground investigation and testing

ISO 14688-1:2002 Geotechnical investigation and testing Identification and classification of soil Part 1: Identification and description
EN 996:1995+A3:2009 Piling equipment - Safety requirements
ISO 10097-1:1999 Wireline diamond core drilling equipment — System A — Part 1: Metric units
ISO/TS 22475-2:2006 Geotechnical investigation and testing Sampling methods and groundwater measurements Part 2: Qualification criteria for enterprises and personnel
EN 791:1995+A1:2009 Drill rigs - Safety
ISO 14689-1:2003 Geotechnical investigation and testing Identification and classification of rock Part 1: Identification and description
ISO 22476-3:2005 Geotechnical investigation and testing — Field testing — Part 3: Standard penetration test
ISO 3552-1:1992 Rotary core diamond drilling equipment — System B — Part 1: Metric units
EN 1997-2:2007/AC:2010 EUROCODE 7 - GEOTECHNICAL DESIGN - PART 2: GROUND INVESTIGATION AND TESTING
ISO 3551-1:1992 Rotary core diamond drilling equipment — System A — Part 1: Metric units
BS 879-2:1988 Water well casing Specification for thermoplastics tubes for casing and slotted casing
EN 1997-1:2004/A1:2013 EUROCODE 7: GEOTECHNICAL DESIGN - PART 1: GENERAL RULES
BS 879-1:1985 Water well casing Specification for steel tubes for casing

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.