I.S. CEN TS 14578:2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
PLASTICS PIPING SYSTEMS FOR WATER SUPPLY OR DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GPR) BASED ON UNSATURATED POLYESTER RESIN (UP) - RECOMMENDED PRACTICE FOR INSTALLATION
Hardcopy , PDF
22-12-2013
English
01-01-2003
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Procedures
4.1 General
4.2 Special conditions for pipe having a nominal
stiffness less than SN 1250
5 Specific information and recommendations
5.1 General
5.2 Specific transportation requirements
5.3 Maximum storage heights on site
5.4 Maximum storage period in direct sunlight
5.5 Any climatic conditions requiring special storage
5.6 Limiting deflections
5.7 Coefficient of linear expansion
5.8 Longitudinal tensile modulus and strength
5.9 Suitability for use in areas exposed to sunlight
5.10 Appropriate jointing system
5.11 Cold bending
5.12 Permitted rates of loss of water and/or pressure
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.