Preview

I.S. EN 1218-4:2004

Superseded

Preview

SAFETY OF WOODWORKING MACHINES - TENONING MACHINES - PART 4: EDGE BANDING MACHINES FED BY CHAIN(S)

Available format(s)

Hardcopy , PDF

Superseded date

28-09-2015

Language(s)

English

Published date

01-01-2004

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
  3.1 General
  3.2 Terms
  3.3 Definitions
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 General
  5.2 Controls
      5.2.1 Safety and reliability of control systems
      5.2.2 Position of controls
      5.2.3 Starting
      5.2.4 Stop controls
      5.2.5 Emergency stop
      5.2.6 Integrated feed
      5.2.7 Mode selection
      5.2.8 Speed changing
      5.2.9 Control duplication
      5.2.10 Failure of the power supply
      5.2.11 Failure of the control circuits
  5.3 Protection against mechanical hazards
      5.3.1 Stability
      5.3.2 Risk of break-up during operation
      5.3.3 Tool holder and tool design
      5.3.4 Braking
      5.3.5 Devices to minimise the possibility or the effect of
             ejection or kick-back
      5.3.6 Work-piece supports and guides
      5.3.7 Prevention of access to moving parts
  5.4 Protection against non-mechanical hazards
      5.4.1 Fire
      5.4.2 Noise
      5.4.3 Emission of chips, and dust
      5.4.4 Electricity
      5.4.5 Ergonomics and Handling
      5.4.6 Lighting
      5.4.7 Pneumatics
      5.4.8 Hydraulics
      5.4.9 Heat
      5.4.10 Substances
      5.4.11 Electromagnetic compatibility
      5.4.12 Static Electricity
      5.4.13 Errors of fitting
      5.4.14 Isolation
      5.4.15 Maintenance
6 Information for use
  6.1 Warning devices
  6.2 Marking
  6.3 Instruction handbook
Annex A (informative) Examples of safety related control systems
Annex B (normative) Tool spindle dimensional tolerances
Annex ZA (informative) Relationship between this European Standard
         and the Essential Requirements of EU Directive 98/37/EC
Annex ZB (informative) Relationship between this European Standard
         and the Essential Requirements of EU Directive 2006/42/EC
Bibliography

Describes all the significant hazards, hazardous situations and events as listed in Clause 4 which are relevant to edge banding machines fed by chain(s) where the loading and unloading is manual and where the maximum work-piece height capacity is 75 mm.

DevelopmentNote	2004 Edition Re-issued in August 2009 & incorporates AMD 2 2009. (08/2009)
DocumentType	Standard
Pages	54
PublisherName	National Standards Authority of Ireland
Status	Superseded

Standards	Relationship
DIN EN 1218-4:2009-12	Identical
UNI EN 1218-4 : 2009	Identical
EN 1218-4:2004+A2:2009	Identical
UNE-EN 1218-4:2005	Identical
BS EN 1218-4 : 2004	Identical