Preview

I.S. EN 12814-4:2002

Superseded

Preview

TESTING OF WELDED JOINTS OF THERMOPLASTICS SEMI-FINISHED PRODUCTS - PART 4: PEEL TEST

Available format(s)

Hardcopy , PDF

Superseded date

29-04-2018

Language(s)

English

Published date

01-01-2002

Publisher

National Standards Authority of Ireland

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
European foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and designations
5 T-peel test
6 Decohesion test
7 Crush test
8 Test report
Bibliography

Defines the dimensions, the method of sampling and the preparation of the test specimens, and also the conditions for performing the peel test perpendicular to the weld in order to determine the peel resistance and the failure behaviour.

DocumentType	Standard
Pages	18
PublisherName	National Standards Authority of Ireland
Status	Superseded

Standards	Relationship
SN EN 12814-4 : 2001	Identical
DIN EN 12814-4:2001-12	Identical
UNI EN 12814-4 : 2003	Identical
NS EN 12814-4 : 1ED 2001	Identical
UNE-EN 12814-4:2002	Identical
NBN EN 12814-4 : 2001	Identical
BS EN 12814-4:2001	Identical
ONORM EN 12814-4 : 2003	Identical
NF EN 12814-4 : 2002	Identical
EN 12814-4:2018	Identical
NEN EN 12814-4 : 2018	Identical

EN 1555-3:2010+A1:2012	Plastics piping systems for the supply of gaseous fuels - Polyethylene (PE) - Part 3: Fittings
EN 12201-3:2011+A1:2012	Plastics piping systems for water supply, and for drainage and sewerage under pressure - Polyethylene (PE) - Part 3: Fittings
CEN/TS 16892:2015	Plastics - Welding of thermoplastics - Specification of welding procedures
EN 14728:2005	Imperfections in thermoplastic welds - Classification
ISO 13954:1997	Plastics pipes and fittings Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm
ISO 13955:1997	Plastics pipes and fittings Crushing decohesion test for polyethylene (PE) electrofusion assemblies
ISO 5893:2002	Rubber and plastics test equipment Tensile, flexural and compression types (constant rate of traverse) Specification