I.S. EN 13463-2:2005
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Hardcopy , PDF
09-04-2020
English
01-01-2005
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General
4.1 General requirements
4.2 Determination of suitability
5 Specific requirements and limitations
5.1 Nature of ignition source
5.2 Test requirements
5.3 Enclosures without the provision for carrying out
checks after installation
5.4 Enclosures with provisions for carrying out checks
after installation
5.5 Resilient gaskets
5.6 Poured seals and encapsulating compounds
5.7 Internal fans or similar devices
5.8 Limits of operation
6 Verifications and tests
6.1 Preconditioning for seals and gaskets used to
maintain the flow restricting effect
6.2 Tests
6.2.1 Equipment with provisions for checking of
flow restricting properties
6.2.2 Equipment without provisions for checking of
flow restricting properties
6.2.3 Equipment where the nominal volume of the
enclosure changes due to pressure
6.2.4 Routine production test
7 Instructions for use
8 Marking
Annex ZA (informative) Clauses of this European Standard
addressing essential requirements
or other provisions of EU Directives
Bibliography
Important note : All end users must be registered with an Account prior to user licenses being assigned.Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.