• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

I.S. EN 45545-2:2013

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

RAILWAY APPLICATIONS - FIRE PROTECTION ON RAILWAY VEHICLES - PART 2: REQUIREMENTS FOR FIRE BEHAVIOUR OF MATERIALS AND COMPONENTS
Available format(s)

Hardcopy , PDF

Superseded date

14-09-2020

Language(s)

English

Published date

01-01-2013

Preview

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
5 Test properties
6 Evaluation of conformity
Annex A (normative) - Standard vandalism test for
        seat coverings
Annex B (normative) - Fire test method for seating
Annex C (normative) - Testing methods for determination
        of toxic gases from railway products
Annex D (normative) - Protocol for test specimen
        preparation in standard tests
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 2008/57/EC
Bibliography

Defines the reaction to fire performance requirements for materials and products used on railway vehicles as defined in EN 45545-1.

DevelopmentNote
Supersedes SR CEN/TS 45545-2. (03/2013) 2013 Edition Re-Issued in November 2015 & incorporates AMD 1 2015. (11/2015)
DocumentType
Standard
Pages
78
PublisherName
National Standards Authority of Ireland
Status
Superseded
SupersededBy
Supersedes

Standards Relationship
EN 45545-2:2013+A1:2015 Identical

ISO 2719:2016 Determination of flash point Pensky-Martens closed cup method
ISO 5660-1:2015 Reaction-to-fire tests Heat release, smoke production and mass loss rate Part 1: Heat release rate (cone calorimeter method) and smoke production rate (dynamic measurement)
ISO 5658-2:2006 Reaction to fire tests Spread of flame Part 2: Lateral spread on building and transport products in vertical configuration
ISO 9705:1993 Fire tests Full-scale room test for surface products
ISO 1716:2010 Reaction to fire tests for products Determination of the gross heat of combustion (calorific value)
ISO 5659-2:2017 Plastics — Smoke generation — Part 2: Determination of optical density by a single-chamber test
EN ISO 12952-2:2010 Textiles - Assessment of the ignitability of bedding items - Part 2: Ignition source: match-flame equivalent (ISO 12952-2:2010)
EN ISO 5659-2:2017 Plastics - Smoke generation - Part 2: Determination of optical density by a single-chamber test (ISO 5659-2:2017)
ISO 11925-2:2010 Reaction to fire tests Ignitability of products subjected to direct impingement of flame Part 2: Single-flame source test
EN ISO 1182:2010 Reaction to fire tests for products - Non-combustibility test (ISO 1182:2010)
EN 45545-1 : 2013 COR 2013 RAILWAY APPLICATIONS - FIRE PROTECTION ON RAILWAY VEHICLES - PART 1: GENERAL
2008/57/EC : 2008 AMD 5 2014 DIRECTIVE 2008/1957/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL OF 17 JUNE 2008 ON THE INTEROPERABILITY OF THE RAIL SYSTEM WITHIN THE COMMUNITY (RECAST) (TEXT WITH EEA RELEVANCE)
EN 60332-1-2:2004/A11:2016 TESTS ON ELECTRIC AND OPTICAL FIBRE CABLES UNDER FIRE CONDITIONS - PART 1-2: TEST FOR VERTICAL FLAME PROPAGATION FOR A SINGLE INSULATED WIRE OR CABLE - PROCEDURE FOR 1 KW PRE-MIXED FLAME (IEC 60332-1-2:2004/A1:2015)
EN 13238:2010 Reaction to fire tests for building products - Conditioning procedures and general rules for selection of substrates
ISO 6507-3:2005 Metallic materials Vickers hardness test Part 3: Calibration of reference blocks
ISO 1182:2010 Reaction to fire tests for products Non-combustibility test
NFX 70 100-2 : 2006 FIRE TESTS - ANALYSIS OF GASEOUS EFFLUENTS - PART 2: TUBULAR FURNACE THERMAL DEGRADATION METHOD
ISO/TR 9705-2:2001 Reaction-to-fire tests Full-scale room tests for surface products Part 2: Technical background and guidance
EN ISO 9239-1:2010 Reaction to fire tests for floorings - Part 1: Determination of the burning behaviour using a radiant heat source (ISO 9239-1:2010)
ISO 19702:2015 Guidance for sampling and analysis of toxic gases and vapours in fire effluents using Fourier Transform Infrared (FTIR) spectroscopy
EN 61034-2:2005/A1:2013 MEASUREMENT OF SMOKE DENSITY OF CABLES BURNING UNDER DEFINED CONDITIONS - PART 2: TEST PROCEDURE AND REQUIREMENTS (IEC 61034-2:2005/A1:2013)
ISO 12952-2:2010 Textiles Assessment of the ignitability of bedding items Part 2: Ignition source: match-flame equivalent
NFX 70 100-1 : 2006 FIRE TESTS - ANALYSIS OF GASEOUS EFFLUENTS - PART 1: METHODS FOR ANALYSING GASES STEMMING FROM THERMAL DEGRADATION
EN 45545-3:2013 Railway applications - Fire protection on railway vehicles - Part 3: Fire resistance requirements for fire barriers
EN 60584-1:2013 Thermocouples - Part 1: EMF specifications and tolerances
EN 50305:2002 Railway applications - Railway rolling stock cables having special fire performance - Test methods
EN ISO 4589-2:2017 Plastics - Determination of burning behaviour by oxygen index - Part 2: Ambient-temperature test (ISO 4589-2:2017)
EN 61034-1:2005/A1:2014 MEASUREMENT OF SMOKE DENSITY OF CABLES BURNING UNDER DEFINED CONDITIONS - PART 1: TEST APPARATUS (IEC 61034-1:2005/A1:2013)
ISO 4589-2:2017 Plastics — Determination of burning behaviour by oxygen index — Part 2: Ambient-temperature test
EN 60332-3-24 : 2009 TESTS ON ELECTRIC AND OPTICAL FIBRE CABLES UNDER FIRE CONDITIONS - PART 3-24: TEST FOR VERTICAL FLAME SPREAD OF VERTICALLY-MOUNTED BUNCHED WIRES OR CABLES - CATEGORY C
ISO 9239-1:2010 Reaction to fire tests for floorings Part 1: Determination of the burning behaviour using a radiant heat source
EN 45545-5:2013+A1:2015 Railway applications - Fire protection on railway vehicles - Part 5: Fire safety requirements for electrical equipment including that of trolley buses, track guided buses and magnetic levitation vehicles
EN ISO 1716:2010 Reaction to fire tests for products - Determination of the gross heat of combustion (calorific value) (ISO 1716:2010)
EN ISO 11925-2:2010/AC:2011 REACTION TO FIRE TESTS - IGNITABILITY OF PRODUCTS SUBJECTED TO DIRECT IMPINGEMENT OF FLAME - PART 2: SINGLE-FLAME SOURCE TEST
EN 60695-2-11:2014 Fire hazard testing - Part 2-11: Glowing/hot-wire based test methods - Glow-wire flammability test method for end-products (GWEPT) (IEC 60695-2-11:2014)

View more information
£95.18
Excluding VAT

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.