I.S. EN 692:2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
Hardcopy , PDF
11-04-2018
English
01-01-2005
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
1 Scope
2 Normative references
3 Terms, definitions and abbreviations
3.1 Terms and definitions
3.2 Abbreviations
4 List of significant hazards
5 Safety requirements and/or measures
5.1 Introduction
5.2 Basic design considerations
5.2.1 Brakes and clutches
5.2.2 Presses with part revolution clutches
(friction clutches)
5.2.3 Hydraulic and pneumatic systems - Common
features
5.2.4 Pneumatic systems
5.2.5 Hydraulic systems
5.2.6 Slide adjustment and stroke adjustment
5.3 Mechanical hazards in the tools area
5.4 The control and monitoring system
5.4.1 Control and monitoring functions
5.4.2 Part revolution clutch presses: redundancy
and monitoring of clutch/brake control systems,
and overrun monitoring for single cycle use
5.4.3 Muting
5.4.4 Programmable electronic systems (PES),
programmable pneumatic systems (PPS) and safety
related functions
5.4.5 Selector switches
5.4.6 Isolation switch
5.4.7 Position switches
5.4.8 Control devices
5.4.9 Valves
5.5 Tool-setting, trial strokes, maintenance
and lubrication
5.6 Mechanical hazards - other
5.7 Slips, trips and falls
5.8 Protection against other hazards
5.8.1 Electrical hazards
5.8.2 Thermal hazards
5.8.3 High pressure fluid ejection hazards
5.8.4 Hazards generated by noise
5.8.5 Hazards generated by vibration
5.8.6 Hazards generated by materials and
substances
5.8.7 Hazards generated by neglecting
ergonomic principles
6 Verification of the safety requirements and/or measures
7 Information for use
7.1 Marking
7.2 Instruction handbook
Annex A (normative) - Interlocking guards
A.1 Presses with part revolution clutches
Annex B (normative) - Calculation of minimum safety distances
Annex C (informative) - Electro-sensitive protective equipment
(ESPE) using active opto-electronic
protective devices (AOPDs)
Annex D (informative) - Closed tools
Annex E (informative) - The setting of the rotary cam
arrangement
E.1 Basic features of the eccentric adjustment
and rotary cam arrangement
E.2 Determination of the position where
muting begins
Annex F (informative) - Determination of the overall response
time T
Annex G (normative) - Conditions for noise measurement of
mechanical presses
Annex ZA (informative) - Relationship between this European
Standard and the Essential
Requirements of EU Directive 98/37/EC,
amended by Directive 98/79 EC
Annex ZB (informative) - Relationship between this European
Standard and the Essential
Requirements of EU Directive
2006/42/EC
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.