WOODWORKING MACHINES - SAFETY - PART 4: VERTICAL PANEL CIRCULAR SAWING MACHINES (ISO 19085-4:2018)

Published date

27-05-2018

Publisher

National Standards Authority of Ireland

For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.

Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

National Foreword
European foreword
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and measures for controls
6 Safety requirements and measures for protection
  against mechanical hazards
7 Safety requirements and measures for protection
  against other hazards
8 Information for use
Annex A (informative) - Performance level required
Annex B (normative) - Test for braking function
Annex C (normative) - Stability test for displaceable machines
Annex D (normative) - Impact test for guards
Annex E (normative) - Noise emission measurement for
        machines not in ISO 7960:1995
Annex F (normative) - Riving knife longitudinal and
        lateral stability tests
Annex ZA (informative) - Relationship between this
         European standard and the essential requirements
         of EU Directive 2006/42/EC

Defines the safety requirements and measures for manually loaded and unloaded stationary vertical panel sawing machines, hereinafter referred to as 'machines'.

DocumentType	Standard
PublisherName	National Standards Authority of Ireland
Status	Current

Standards	Relationship
EN ISO 19085-4:2018	Identical

ISO 7960:1995	Airborne noise emitted by machine tools Operating conditions for woodworking machines
ISO 12100:2010	Safety of machinery — General principles for design — Risk assessment and risk reduction
ISO 19085-1:2017	Woodworking machines Safety Part 1: Common requirements
ISO 13857:2008	Safety of machinery Safety distances to prevent hazard zones being reached by upper and lower limbs
EN 847-1:2017	Tools for woodworking - Safety requirements - Part 1: Milling tools, circular saw blades
ISO 13849-1:2015	Safety of machinery — Safety-related parts of control systems — Part 1: General principles for design