1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
    3.1 Terms and definitions
    3.2 Symbols
    3.3 Abbreviations
4 General requirements
    4.1 General
    4.2 Mechanical requirements
    4.3 Accessible parts
    4.4 Laser radiation
5 Protection against environmental influences
6 Equipotential bonding and earthing
    6.1 General requirements
    6.2 Equipotential bonding mechanisms
    6.3 Equipotential bonding in meshed systems
         6.3.1 References to other standards
         6.3.2 General on a.c. mains
         6.3.3 AC power distribution and connection of
                the protective conductor
         6.3.4 Dangers and malfunction
         6.3.5 Measures
7 Mains-supplied equipment
8 Remote power feeding in cable networks
    8.1 Remote power feeding
         8.1.1 Maximum allowed voltages
         8.1.2 General provisions for equipment
         8.1.3 Current-carrying capacity and dielectric
                strength of the components
    8.2 Remote powering from subscriber premises
9 Protection against contact and proximity to electric
    power distribution systems
    9.1 General
    9.2 Overhead lines
         9.2.1 Overhead lines up to 1000 V
         9.2.2 Overhead lines above 1000 V
    9.3 House installations up to 1000 V
10 System outlets and transfer points
    10.1 General
    10.2 System outlet
         10.2.1 Fully isolated system outlet
         10.2.2 Semi-isolated system outlet
         10.2.3 Non-isolated system outlet with protective
                element
         10.2.4 Non-isolated system outlet without protective
                element
    10.3 Transfer point
11 Protection against atmospheric over-voltages and
    elimination of potential differences
    11.1 General
    11.2 Protection of the antenna system
         11.2.1 Building equipped with a lightning protection
                system (LPS)
         11.2.2 Building not equipped with an LPS
    11.3 Earthing and bonding of the antenna system
         11.3.1 Earthing and bonding mechanisms
         11.3.2 Earth termination system
         11.3.3 Earthing conductors
    11.4 Over-voltage protection
12 Mechanical stability
    12.1 General requirements
    12.2 Bending moment
    12.3 Wind-pressure values
    12.4 Mast construction
    12.5 Data to be published
Annex A (informative) Use of shield wires to protect
         installations with coaxial cables
Annex B (informative) Special conditions using IT power
         line Networks
Annex ZA (normative) Special national conditions
Annex ZB (informative) A-deviations
Annex ZC (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography