NBN EN 60927 : 2008 AMD 1 2014

Committees responsible
National foreword
Foreword
Section one - General requirements
1 Scope
2 Definitions
3 General requirements for tests
4 Marking
Section two - Performance requirements for starters
                (other than glow starters) for
                fluorescent lamps
5 Scope
6 Starting test
7 Endurance test
8 Deactivated lamp test
Section three - Performance requirements for ignitors
9 Scope
10 Starting test
11 Non-reoperating level
12 Endurance test
Annexes
A (normative) Ballasts to be used for life testing
B (informative) Explanation of starting conditions
    for electronic starters with an electronic
    switching element
C (informative) A guide to quoting product life and
    failure rate
ZA (normative) Normative references to international
    publications with their corresponding European
    publications
Figure 1 - Pulse voltage measurement for starting devices
Figure 2 - Ignition energy measurement for non-triggered
           starting devices
Figure B.1 - Cathode heating current requirements for
           electronic starters with electronics
           switching element
Figure B.2 - Interpretation of effective heating current
Figure B.3.1 - Starters which remove pre-heating current
           when open-circuit voltages are elevated
Figure B.3.2 - Starters which have open-circuit voltage
           transition times higher than 100 ms
Table 1 - Starting aid requirements