Foreword
1 Scope
2 Normative references
3 Definitions
4 Designations
      4.1 Material
      4.2 Material condition
      4.3 Product
5 Ordering information
6 Requirements
      6.1 Composition
      6.2 Mechanical properties
      6.3 Dimensions and tolerances
      6.4 Surface quality
      6.5 Technological requirements
7 Sampling
      7.1 General
      7.2 Analysis
      7.3 Mechanical tests and stress corrosion
             resistance test
8 Test methods
      8.1 Analysis
      8.2 Tensile test
      8.3 Hardness test
      8.4 Technological tests
      8.5 Freedom from defect tests
      8.6 Retests
      8.7 Rounding of results
9 Declaration of conformity and inspection
      documentation
      9.1 Declaration of conformity
      9.2 Inspection documentation
10 Marking, packaging, labelling
Table 1 - Composition of copper
Table 2 - Composition of low alloyed copper alloys
Table 3 - Composition of copper-nickel alloys
Table 4 - Composition of copper-nickel-zinc alloys
Table 5 - Composition of copper-tin alloys
Table 6 - Composition of binary copper-zinc alloys
Table 7 -Composition of copper-zinc-lead alloys
Table 8 - Composition of complex copper-zinc alloys
Table 9 - Mechanical properties of copper and low
          alloyed copper alloys
Table 10 - Mechanical properties of copper-nickel
           alloys
Table 11 - Mechanical properties of copper-nickel-zinc
           alloys
Table 12 - Mechanical properties of copper-tin alloys
Table 13 - Mechanical properties of binary copper-zinc
           alloys
Table 14 - Mechanical properties of copper-zinc-lead
           alloys
Table 15 - Mechanical properties of complex copper-zinc
           alloys
Table 16 - Tolerances on diameter
Table 17 - Tolerances on wall thickness
Table 18 - Tolerances on fixed lengths, tubes in
           straight lengths
Table 19 - Tolerances on fixed lengths, tube in coils
           (not level wound)
Table 20 - Tolerances on diameter including deviation
           from circular form, tube in coils
Table 21 - Tolerances on straightness
Table 22 - Sampling rate
Annex A (informative) Bibliography