We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • NEN EN 848-3 : 2012

    Current The latest, up-to-date edition.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    SAFETY OF WOODWORKING MACHINES - ONE SIDE MOULDING MACHINES WITH ROTATING TOOL - PART 3: NUMERICALLY CONTROLLED (NC) BORING AND ROUTING MACHINES

    Available format(s): 

    Language(s): 

    Published date:  13-01-2013

    Publisher:  Netherlands Standards

    Add to Watchlist

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

          Foreword
          Introduction
    1 Scope
    2 Normative references
    3 Definitions
    4 List of hazards
    5 Safety requirements and/or measures
          5.1 Controls
          5.2 Protection against mechanical hazards
          5.3 Protection against non-mechanical hazards
    6 Information for use
          6.1 Warning devices
          6.2 Marking
          6.3 Instruction handbook
    Annex A (informative) Safe working practice
    Annex B (normative) Operating conditions for noise
                        measurements
    Annex ZA (informative) Clauses of this European Standard
                           addressing essential requirements or
                           other provisions of EU Directives

    Abstract - (Show below) - (Hide below)

    Defines all significant hazards, hazardous situations and events, which are relevant to NC boring machines, NC routing machines and NC combined boring/routing machines herein after referred to as "machines" designed to cut solid wood, chip board, fibreboard, plywood and also these materials where these are covered with plastic/light alloy laminate or edgings when they are used as intended and under the conditions foreseen by the manufacturer including reasonably foreseeable misuse.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher Netherlands Standards
    Status Current
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective