NF EN 416-1 : 2009

Superseded

View Superseded by

SINGLE BURNER GAS-FIRED OVERHEAD RADIANT TUBE HEATERS FOR NON-DOMESTIC USE - PART 1: SAFETY

Superseded date

05-10-2021

Published date

12-01-2013

Publisher

Association Francaise de Normalisation

Avant-propos
1 Domaine d'application
2 Références normatives
3 Définitions
4 Classification des appareils
5 Exigences de construction
6 Exigences de fonctionnement
7 Méthodes d'essais
8 Marquage et notices
9 Évaluation de la conformité des POCED et des terminaux
  associés
Annexe A (informative) Situations nationales
Annexe B (normative) Types (de conduits d'évacuation)
         d'appareils
Annexe C (informative) Règles d'équivalence
Annexe D (informative) Calcul du débit massique des
         produits de combustion
Annexe E (informative) Identification des types de gaz en
         vigueur dans divers pays
Annexe F (normative) Conditions nationales spéciales
Annexe G (informative) Exemple de calcul des facteurs de
         pondération pour un appareil à plusieurs allures
Annexe H (informative) Calculs de conversions de NOx
Annexe I (informative) Solutions relatives aux pays dont les
         organismes nationaux sont membres associés du CEN
Annexe J (informative) Modèle de plans d'échantillonnage
Annexe K (informative) Détermination des pertes par les
         fumées
Annexe ZA (informative) Relations entre la présente norme
          européenne et les exigences essentielles de la
          Directive UE 90/396/CEE relative au rapprochement
          des législations des États membres concernant les
          appareils à gaz
Annexe ZB (informative) Articles de la présente norme
          européenne traitant des dispositions de la
          Directive UE Produits de construction
Bibliographie

Gives the requirements and test procedures for the safety, construction, classification and marking of non-domestic gas fired overhead radiant tube heaters that include a single burner control system. Applies to type A[2], A[3], B[12], B[13], B[22], B[23], C[12], C[13], C[32] and C[33] appliances, intended for use in other than domestic dwellings, in which the supply of combustion air and/or the evacuation of the products of combustion is achieved by mechanical means located upstream of the draught diverter, if provided.

DevelopmentNote	Indice de classement: E31-402-1. Supersedes NFE 31 402. (04/2002) PR NF EN 416-1 November 2006. (11/2006)
DocumentType	Standard
PublisherName	Association Francaise de Normalisation
Status	Superseded
SupersededBy	NF EN 17175:2019 NF EN 416:2019
Supersedes	NFE 31 402 : 89 XP

Standards	Relationship
EN 416-1:2009	Identical
UNE-EN 416-1:2009	Identical
NEN EN 416-1 : 2009	Identical
DIN EN 416-1:2009-09	Identical
NBN EN 416-1 : 2009	Identical
BS EN 416-1:2009	Identical
UNI EN 416-1 : 2009	Identical
I.S. EN 416-1:2009	Identical
SN EN 416-1 : 2009	Identical
NS EN 416-1 : 2009	Identical

NF EN 416-2 : 2006

SINGLE BURNER GAS-FIRED OVERHEAD RADIANT TUBE HEATERS FOR NON-DOMESTIC USE - PART 2: RATIONAL USE OF ENERGY

NF EN 60335-2-102 : 2016	HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES - SAFETY - PART 2-102: PARTICULAR REQUIREMENTS FOR GAS, OIL AND SOLID-FUEL BURNING APPLIANCES HAVING ELECTRICAL CONNECTIONS
NF EN ISO 228-1 : 2003	PIPE THREADS WHERE PRESSURE-TIGHT JOINTS ARE NOT MADE ON THE THREADS - PART 1: DIMENSIONS, TOLERANCES AND DESIGNATION
ISO 7005-2:1988	Metallic flanges — Part 2: Cast iron flanges
NF EN 88-1 : 2011 + A1 2016	PRESSURE REGULATORS AND ASSOCIATED SAFETY DEVICES FOR GAS APPLIANCES - PART 1: PRESSURE REGULATORS FOR INLET PRESSURES UP TO AND INCLUDING 50 KPA
NF EN 437 : 2003 + A1 2009	TEST GASES - TEST PRESSURES - APPLIANCE CATEGORIES
ISO 274:1975	Copper tubes of circular section — Dimensions
ISO 7005-3:1988	Metallic flanges Part 3: Copper alloy and composite flanges
NF EN 126 : 2012	MULTIFUNCTIONAL CONTROLS FOR GAS BURNING APPLIANCES
NF EN 60529 : 92 AMD 2 2014	DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE)
NF EN 13410 : 2001	GAS-FIRED OVERHEAD RADIANT HEATERS - VENTILATION REQUIREMENTS FOR NON-DOMESTIC PREMISES
NF EN 60335-1 : 2013	HOUSEHOLD AND SIMILAR ELECTRICAL APPLIANCES - SAFETY - PART 1: GENERAL REQUIREMENTS
CR 1404:1994	Determination of emissions from appliances burning gaseous fuels during type-testing
NF EN 257 : 2011	MECHANICAL THERMOSTATS FOR GAS-BURNING APPLIANCES
NF EN ISO 3166-1 : 2014	CODES FOR THE REPRESENTATION OF NAMES OF COUNTRIES AND THEIR SUBDIVISION - PART 1: COUNTRY CODES
NF EN 60584-2 : 1993	THERMOCOUPLES - PART 2: TOLERANCES
NF EN 10226-1 : 2004	PIPE THREADS WHERE PRESSURE TIGHT JOINTS ARE MADE ON THE THREADS - PART 1: TAPER EXTERNAL THREADS AND PARALLEL INTERNAL THREADS - DIMENSIONS, TOLERANCES AND DESIGNATION
ISO 7005-1:2011	Pipe flanges — Part 1: Steel flanges for industrial and general service piping systems
NF EN ISO 6976 : 2017	NATURAL GAS - CALCULATION OF CALORIFIC VALUES, DENSITY, RELATIVE DENSITY AND WOBBE INDICES FROM COMPOSITION
NF EN 161 : 2011 + A3 2013	AUTOMATIC SHUT-OFF VALVES FOR GAS BURNERS AND GAS APPLIANCES
NF EN 298 : 2012	AUTOMATIC BURNER CONTROL SYSTEMS FOR BURNERS AND APPLIANCES BURNING GASEOUS OR LIQUID FUELS
NF EN 10226-2 : 2005	PIPE THREADS WHERE PRESSURE TIGHT JOINTS ARE MADE ON THE THREADS - PART 2: TAPER EXTERNAL THREADS AND TAPER INTERNAL THREADS - DIMENSIONS, TOLERANCES AND DESIGNATION
NF EN 60584-1 : 2014	THERMOCOUPLES - PART 1: EMF SPECIFICATIONS AND TOLERANCES

View more information

Sorry this product is not available in your region.

Access your standards online with a subscription

Features

Simple online access to standards, technical information and regulations.
Critical updates of standards and customisable alerts and notifications.
Multi-user online standards collection: secure, flexible and cost effective.

Learn more on subscription solutions

Get in touch with us

Log into your Account

NF EN 416-1 : 2009

Superseded

Table of Contents

Abstract

General Product Information

International Equivalents

Standards Referenced By This Book

Standards Referencing This Book

Category

Subcategory

Access your standards online with a subscription