• There are no items in your cart
We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
Dismiss alert

NF EN 61803 : 2000 AMD 2 2017

Superseded
Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by
superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

DETERMINATION OF POWER LOSSES IN HIGH-VOLTAGE DIRECT CURRENT (HVDC) CONVERTER STATIONS WITH LINE-COMMUTATED CONVERTERS
Amendment of

NF EN 61803:2000

Superseded date

27-10-2021

Published date

12-01-2013

1 Scope
2 Normative references
3 Definitions and symbols
    3.1 Definitions
    3.2 Letter symbols
4 General
    4.1 Introduction
    4.2 Ambient conditions
          4.2.1 Outdoor standard reference temperature
          4.2.2 Coolant standard reference temperature
          4.2.3 Standard reference air pressure
    4.3 Operating parameters
5 Determination of equipment losses
    5.1 Thyristor valve losses
          5.1.1 Thyristor conduction loss per valve
          5.1.2 Thyristor spreading loss per valve
          5.1.3 Other conduction losses per valve
          5.1.4 DC voltage-dependent loss per valve
          5.1.5 Damping loss per valve (resistor-dependent
                  term)
          5.1.6 Damping loss per valve (change of capacitor
                  energy term)
          5.1.7 Turn-off losses per valve
          5.1.8 Reactor loss per valve
          5.1.9 Total valve losses
          5.1.10 Temperature effects
          5.1.11 No-load operation loss per valve
    5.2 Converter transformer losses
          5.2.1 General
          5.2.2 No-load operation losses
          5.2.3 Operating losses
          5.2.4 Auxiliary power losses
    5.3 AC filter losses
          5.3.1 General
          5.3.2 AC filter capacitor losses
          5.3.3 AC filter reactor losses
          5.3.4 AC filter resistor losses
          5.3.5 Total a.c. filter losses
    5.4 Shunt capacitor bank losses
    5.5 Shunt reactor losses
    5.6 DC smoothing reactor losses
    5.7 DC filter losses
          5.7.1 General
          5.7.2 DC filter capacitor losses
          5.7.3 DC filter reactor losses
          5.7.4 DC filter resistor losses
          5.7.5 Total d.c. filter losses
    5.8 Auxiliaries and station service losses
    5.9 Radio interference/PLC filter losses
    5.10 Other equipment losses
Annex A (normative) Calculation of harmonic currents and
voltages
      A.1 Harmonic currents in converter transformers
      A.2 Harmonic currents in a.c. filters
      A.3 Harmonic voltages on the d.c. side
      A.4 DC side harmonic currents in the smoothing reactor
Annex B (informative) Typical station losses
Annex C (informative) Bibliography
Annex ZA (normative) Normative references to international
publications with their corresponding European publications

Applicable to all line-commutated high-voltage direct current (HVDC) converter stations for the use of power exchange in utility systems. Presumes the use of 12-pulse thyristor converters, but can, also be used for 6-pulse thyristor converters (to be used with due care). Gives a set of procedures for the determination of the total losses of an HVDC converter station. These procedures covers all parts, and addresses no-load operation and operating losses together with their methods of calculation which use, when possible, measured parameters.

DevelopmentNote
Indice de classement: C53-243. (10/2011)
DocumentType
Standard
PublisherName
Association Francaise de Normalisation
Status
Superseded
SupersededBy

NF EN 60076-1 : 2012 POWER TRANSFORMERS - PART 1: GENERAL
NF EN 60289 : 96 AMD 11 2002 REACTORS
IEC 60871-1:2014 Shunt capacitors for a.c. power systems having a rated voltage above 1 000 V - Part 1: General
IEC 60700-1:2015 Thyristor valves for high voltage direct current (HVDC) power transmission - Part 1: Electrical testing
IEC 60076-1:2011 Power transformers - Part 1: General
IEC 60633:1998+AMD1:2009+AMD2:2015 CSV Terminology for high-voltage direct current (HVDC) transmission
IEC 60747-6:2016 Semiconductor devices - Part 6: Discrete devices - Thyristors
IEC 60289:1988 Reactors
EN 60633:1999/A2:2015 TERMINOLOGY FOR HIGH-VOLTAGE DIRECT CURRENT (HVDC) TRANSMISSION (IEC 60633:1998/A2:2015)

View more information
Sorry this product is not available in your region.

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.