Foreword
1 Scope
  1.1 General
  1.2 Type of fasteners and fastening groups
  1.3 Fastener dimensions and materials
  1.4 Fastener loading
      1.4.1 Type of loading
      1.4.2 Direction of loading
  1.5 Concrete strength
  1.6 Concrete member loading
2 Normative references
3 Definitions and symbols
  3.1 Definitions
  3.2 Notations
      3.2.1 Indices
      3.2.2 Actions and Resistances
      3.2.3 Concrete and steel
      3.2.4 Units
4 Basis of design
  4.1 General
  4.2 Required verifications
  4.3 Design format
  4.4 Verification by the partial factor method
      4.4.1 General
      4.4.2 Partial factors for indirect and fatigue actions
      4.4.3 Partial factors for resistance
  4.5 Project specification and installation of fasteners
5 Determination of concrete condition and action effects
  5.1 Non-cracked and cracked concrete
  5.2 Derivation of forces acting on fasteners
      5.2.1 General
      5.2.2 Tension loads
      5.2.3 Shear loads
6 Verification of ultimate limit state
  6.1 General
7 Verification of fatigue limit state
  7.1 General
  7.2 Derivation of loads acting on fasteners
  7.3 Resistance
8 Verification for seismic loading
  8.1 General
  8.2 Requirements
  8.3 Actions
  8.4 Resistance
9 Verification of serviceability limit state
Annex A (normative) - Local transmission of fastener
        loads into the concrete member
  A.1 General
  A.2 Verification of the shear resistance of the concrete
      member
  A.3 Verification of the resistance to splitting forces
Annex B (normative) - Plastic design approach, fastenings
        with headed fasteners and post-installed fasteners
  B.1 Field of application
  B.2 Loads on fastenings
  B.3 Design of fastenings
      B.3.1 Partial factors
      B.3.2 Resistance to tension load
      B.3.3 Resistance to shear load
Annex C (informative) - Durability
  C.1 General
  C.2 Fasteners in dry, internal conditions
  C.3 Fasteners in external atmospheric or in
      permanently damp internal exposure
  C.4 Fasteners in high corrosion exposure by
      chloride and sulphur dioxide
Annex D (informative) - Exposure to fire - design method
  D.1 General
  D.2 Partial factors
  D.3 Resistance under fire exposure
      D.3.1 General
      D.3.2 Tension load
      D.3.3 Shear load
      D.3.4 Combined tension and shear load
Annex E (informative) - Recommended additions and alterations
        to EN 1998-1:2004, 4.3.5 (Design of structures for
        earthquake resistance) for the design of fastenings
        under seismic loading
  E.1 General
  E.2 Additions to Section 4.3.5.1 of EN 1998-1:2004
  E.3 Additions and alterations to EN 1998-1:2004, 4.3.5.2
  E.4 Additions to EN 1998-1:2004, 4.3.5.3
  E.5 Additions and alterations to EN 1998-1:2004, 4.3.5.4