We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • SAE ARP 1383 : 2013

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    AEROSPACE - IMPULSE TESTING OF HYDRAULIC COMPONENTS

    Available format(s): 

    Superseded date:  27-02-2020

    Language(s): 

    Published date:  01-01-2013

    Publisher:  SAE International

    Add to Watchlist

    Sorry this product is not available in your region.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1. SCOPE
    2. REFERENCES
    3. REQUIREMENTS
    4. GENERAL TEST REQUIREMENTS
    5. TEST EQUIPMENT
    6. TEST PROCEDURE
    7. POST TEST REQUIREMENTS
    8. NOTES
    APPENDIX A - DETERMINATION OF TEST CYCLE
                 REQUIREMENTS APPLICABLE TO CATEGORY II
    APPENDIX B - SCATTER FACTORS FOR ASSUMED
                 LOG-NORMAL DISTRIBUTIONS OF FATIGUE LIFE

    Abstract - (Show below) - (Hide below)

    Describes impulse test procedures that are recommended for hydraulic components.

    General Product Information - (Show below) - (Hide below)

    Committee A-6
    Document Type Revision
    Publisher SAE International
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    16/30338730 DC : 0 BS ISO 18387 - AEROSPACE - LINEAR HYDRAULIC UTILITY ACTUATOR - GENERAL SPECIFICATIONS
    10/30203853 DC : 0 BS ISO 22072 - AEROSPACE - ELECTROHYDROSTATIC ACTUATOR (EHA) - CHARACTERISTICS TO BE DEFINED IN PROCUREMENT SPECIFICATIONS
    SAE ARP 4378 : 2017 ACCUMULATOR, HYDRAULIC, WELDED BELLOWS, FACTORY PRE-CHARGED
    ISO 22072:2011 Aerospace Electrohydrostatic actuator (EHA) Characteristics to be defined in procurement specifications
    SAE ARP 6154 : 2017 AEROSPACE FLUID POWER ELECTROHYDROSTATIC MODULE, DESIGN, PERFORMANCE AND TEST RECOMMENDATIONS
    SAE ARP 4493 : 2013 AEROSPACE - DIRECT DRIVE SERVOVALVES
    17/30356394 DC : 0 BS ISO 9206 ED 3 - AEROSPACE - FIXED DISPLACEMENT HYDRAULIC MOTORS - GENERAL SPECIFICATIONS
    MIL H 5440 : H HYDRAULIC SYSTEMS, AIRCRAFT, TYPES 1 AND 11 DESIGN AND INSTALLATION REQUIREMENTS FOR
    MIL V 29592 : 0 VALVE, AIR VENT, AUTOMATIC, HYDRAULIC, LOW PRESSURE TYPE II SYSTEMS, GENERAL SPECIFICATION FOR
    SAE AS 4941 : 2015 AEROSPACE - GENERAL REQUIREMENTS FOR COMMERCIAL AIRCRAFT HYDRAULIC COMPONENTS
    SAE AIR 5914 : 2014 LANDING GEAR FATIGUE SPECTRUM DEVELOPMENT FOR PART 25 AIRCRAFT
    SAE AS 4251 : 2013 COUPLING ASSEMBLIES, NON-LOCKING PROBE STYLE, SELF-ALIGNING, SELF-SEALING DISCONNECTS
    BS ISO 22072 : 2011 AEROSPACE - ELECTROHYDROSTATIC ACTUATOR (EHA) - CHARACTERISTICS TO BE DEFINED IN PROCUREMENT SPECIFICATIONS
    SAE AS 5586 : 2005 GENERAL REQUIREMENTS FOR HYDRAULIC SYSTEM RESERVOIRS
    SAE ARP 1281 : 2002 ACTUATORS: AIRCRAFT FLIGHT CONTROLS, POWER OPERATED, HYDRAULIC, GENERAL SPECIFICATION FOR
    SAE AS 19692 : 2016 AEROSPACE - MILITARY TYPE VARIABLE DELIVERY, PRESSURE COMPENSATED HYDRAULIC PUMP
    SAE ARP 5311 : 2016 AEROSPACE-INTERFACE DEFINITION FOR MECHANICAL ACTUATION SUBSYSTEMS
    SAE AIR 4057 : 2012 SECONDARY FILTERS FOR FLUID SYSTEM RELIABILITY
    SAE AS 5467 : 2016 GENERAL REQUIREMENTS FOR HYDRAULIC FUSE - FLOW RATE
    SAE ARP 1595 : 2013(R2019) DESIGN AND VERIFICATION OF AIRCRAFT NOSE WHEEL STEERING SYSTEMS
    SAE AS 5466 : 2012 AEROSPACE - GENERAL REQUIREMENTS FOR HYDRAULIC FUSE - QUANTITY MEASURING
    SAE ARP 4752 : 2013 AEROSPACE - DESIGN AND INSTALLATION OF COMMERCIAL TRANSPORT AIRCRAFT HYDRAULIC SYSTEMS
    SAE ARP 4940 : 2014 APPLICATION GUIDE FOR AEROSPACE HYDRAULIC MOTORS
    SAE ARP 4379 : 2016 AEROSPACE - ACCUMULATOR, HYDRAULIC, CYLINDRICAL, PISTON SEPARATED
    SAE ARP 4945 : 2013 AEROSPACE-SOLENOID VALVE, HYDRAULIC, THREE WAY, TWO POSITION, DIRECT ACTING
    SAE AIR 4922A : 2015 PRIMARY FLIGHT CONTROL HYDRAULIC ACTUATION SYSTEM INTERFACE DEFINITION
    SAE ARP 4763 : 2017 AEROSPACE - GENERAL REQUIREMENTS FOR HYDRAULIC RELIEF VALVES
    SAE AIR 5992 : 2015 DESCRIPTIONS OF SYSTEMS INTEGRATION TEST RIGS (IRON BIRDS) FOR AEROSPACE APPLICATIONS
    SAE ARP 5796 : 2013 FLIGHT CRITICAL CONTROL VALVES, MILITARY AIRCRAFT

    Standards Referencing This Book - (Show below) - (Hide below)

    SAE AIR 4298 : 2014 IMPULSE TEST MACHINE, SINE WAVE, EQUIPMENT AND OPERATION OF
    SAE AS 603 : 2015 IMPULSE TESTING OF HYDRAULIC HOSE, TUBING, AND FITTING ASSEMBLIES
    DOT/FAA/AR-MMPDS-01 : 20030131 METALLIC MATERIALS PROPERTIES DEVELOPMENT AND STANDARDIZATION (MMPDS)
    SAE AIR 1228 : 2009 STANDARD IMPULSE MACHINE EQUIPMENT AND OPERATION
    SAE AS 4265 : 2013 IMPULSE TESTING OF HYDRAULIC TUBING AND FITTINGS, S-N CURVE
    SAE AS 7997A : 1999(S2018) MOTORS, AIRCRAFT HYDRAULIC, CONSTANT DISPLACEMENT - GENERAL SPECIFICATION FOR
    SAE AS 19692 : 2016 AEROSPACE - MILITARY TYPE VARIABLE DELIVERY, PRESSURE COMPENSATED HYDRAULIC PUMP
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective