We noticed you’re not on the correct regional site. Switch to our AMERICAS site for the best experience.
  • SAE ARP 4404 : 2013

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    Add to Watchlist
    This Standard has been added successfully to your Watchlist.
    Please visit My Watchlist to see all standards that you are watching.
    Please log in or to add this standard to your Watchlist.
    We could not add this standard to your Watchlist.
    Please retry or contact support for assistance.
    You need to be logged in to add this standard to your Watchlist.
    Please log in now or create an account to add.
    You already added this Product in the Watchlist.

    AIRCRAFT ELECTRICAL INSTALLATIONS

    Available format(s):  Hardcopy, PDF

    Superseded date:  14-10-2019

    Language(s):  English

    Published date:  01-11-2013

    Publisher:  SAE International

    Add to Watchlist

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1. SCOPE
    2. APPLICABLE DOCUMENTS
    3. CIRCUIT PROTECTION
    4. FAIL-SAFE FEATURES IN ELECTRIC CIRCUITS
    5. CIRCUITS FOR ESSENTIAL EQUIPMENT
    6. MULTI-ENGINE RELIABILITY
    7. CONNECTORS AND OTHER TERMINATIONS
    8. GROUNDING AND BONDING
    9. WIRE SELECTION AND ROUTING
    10. ALUMINUM WIRE AND CONNECTIONS
    11. WIRE AND CABLE IDENTIFICATION
    12. MAINTENANCE OF ELECTRIC EQUIPMENT
    13. OPERATION AND INSPECTION OF ELECTRIC EQUIPMENT
    14. PROVISIONS FOR ADDITIONAL ELECTRIC EQUIPMENT
    15. EQUIPMENT SELECTION AND INSTALLATION
    16. CORROSION PREVENTION IN ELECTRICAL EQUIPMENT
    17. SYSTEM LOAD DISTRIBUTION
    18. ELECTRIC SYSTEM TESTS
    19. EMERGENCY CONTROLS AND PROCEDURES
    20. AUXILIARY POWER PLANTS
    APPENDIX A - DEFINITIONS
    APPENDIX B - EVALUATION CHECK-OFF LIST FOR ELECTRIC
                 EQUIPMENT
    APPENDIX C - MINIMUM AIR SPACINGS FOR VARIOUS
                 VOLTAGES AND ALTITUDES

    Abstract - (Show below) - (Hide below)

    Specifies design recommendations that will provide a basis for satisfactory and safe electrical installations in transport aircraft.

    General Product Information - (Show below) - (Hide below)

    Committee AE-8A
    Document Type Standard
    Publisher SAE International
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    SAE AIR 5451 : 2017 A GUIDE TO LANDING GEAR SYSTEM INTEGRATION
    FAA AC 25.1701-1 : 2007 CERTIFICATION OF ELECTRICAL WIRING INTERCONNECTION SYSTEMS ON TRANSPORT CATEGORY AIRPLANES
    MIL HDBK 525 : 0 ELECTRICAL WIRING INTERCONNECT SYSTEM (EWIS) INTEGRITY PROGRAM
    SAE AIR 4004 : 2015 GUIDE FOR INSTALLATION OF ELECTRICAL WIRE AND CABLE ON AIRCRAFT LANDING GEAR

    Standards Referencing This Book - (Show below) - (Hide below)

    SAE AS 4373 : 2012 TEST METHODS FOR INSULATED ELECTRIC WIRE
    MIL DTL 5015 : H CONNECTORS, ELECTRICAL, CIRCULAR THREADED, AN TYPE - GENERAL SPECIFICATION FOR
    EIA 5200000 : D2000 GENERIC SPECIFICATION FOR SPECIAL-USE ELECTROMECHANICAL SWITCHES OF CERTIFIED QUALITY
    SAE ARP 4101/5 : 2010 AIRCRAFT CIRCUIT BREAKER AND FUSE ARRANGEMENT
    SAE ARP 1199 : 1998 SELECTION, APPLICATION, AND INSPECTION OF ELECTRIC OVERCURRENT PROTECTIVE DEVICES
    MIL F 15160 : G FUSE, INSTRUMENT, POWER, AND TELEPHONE, GENERAL SPECIFICATION FOR
    MIL STD 704 : F AIRCRAFT ELECTRIC POWER CHARACTERISTICS
    SAE AS 8011 : 1985 MINIMUM PERFORMANCE STANDARDS FOR A-C GENERATORS AND ASSOCIATED REGULATORS
    SAE AIR 1329C : 2014 ELECTRICAL CONNECTORS AND WIRING, COMPATIBILITY OF
    MIL STD 810 : G ENVIRONMENTAL ENGINEERING CONSIDERATIONS AND LABORATORY TESTS
    SAE AIR 1402 : 1977 COMMON TERMINATION METHOD, ELECTRICAL WIRING SYSTEM, APPLICATION OF
    SAE AS 1212 : 2012 ELECTRIC POWER, AIRCRAFT, CHARACTERISTICS AND UTILIZATION OF
    ASTM D 3032 : 2016 : REDLINE Standard Test Methods for Hookup Wire Insulation
    SAE AS 8028 : 1991 POWERPLANT FIRE DETECTION INSTRUMENTS, THERMAL & FLAME CONTACT TYPES (RECIPROCATING AND TURBINE ENGINE POWERED AIRCRAFT)
    SAE AS 5363 : 2016 ELECTROMECHANICAL POWER CONTROLLER/RELAY, GENERAL SPECIFICATION FOR
    SAE AS 24001 : 2014 FUSE HOLDER, BLOCK-TYPE, 1-, 2-, 3-POLE, 35- TO 60-AMPERE, AIRCRAFT
    MIL DTL 81381 : C WIRE, ELECTRIC, POLYIMIDE-INSULATED, COPPER OR COPPER ALLOY
    MIL STD 1353 : C ELECTRICAL CONNECTORS, PLUG-IN SOCKETS AND ASSOCIATED HARDWARE, SELECTION AND USE OF
    MIL E 7016 : F ELECTRIC LOAD AND POWER SOURCE CAPACITY, AIRCRAFT ANALYSIS OF
    MIL STD 889 : C DISSIMILAR METALS
    SAE AS 8023 : 2006 MINIMUM PERFORMANCE STANDARDS FOR AIRBORNE STATIC ELECTRIC POWER INVERTERS
    MIL STD 7080 : 0 SELECTION & INSTALLATION OF AIRCRAFT ELECTRIC EQUIPMENT
    MS 21919 : E CLAMP, LOOP TYPE, CUSHIONED, SUPPORT
    MIL C 85485 : A CABLE, ELECTRIC, FILTER LINE, RADIO FREQUENCY ABSORPTIVE
    MIL STD 464 : C ELECTROMAGNETIC ENVIRONMENTAL EFFECTS REQUIREMENTS FOR SYSTEMS
    SAE AS 22759 : 2014 WIRE, ELECTRICAL, FLUOROPOLYMER-INSULATED, COPPER OR COPPER ALLOY
    SAE ARP 4043 : 1999 FLIGHT LINE GROUNDING AND BONDING OF AIRCRAFT
    SAE ARP1870A:1987(S2012) Aerospace Systems Electrical Bonding and Grounding for Electromagnetic Compatibility and Safety(STABILIZED Aug 2012)
    SAE AS 4372 : 2014 PERFORMANCE REQUIREMENTS FOR WIRE, ELECTRIC, INSULATED COPPER OR COPPER ALLOY
    SAE AIR 1557 : 1979 HIGH AND EXTENDED VIBRATION ENVIRONMENT
    SAE AS 4851 : 2012 RELATIVE THERMAL LIFE AND TEMPERATURE INDEX FOR INSULATED ELECTRIC WIRE
    SAE AS 1831 : 1997 ELECTRICAL POWER, 270 V DC, AIRCRAFT, CHARACTERISTICS AND UTILIZATION OF
    SAE ARP 1308 : 2014 ELECTRICAL CONNECTORS FOR AEROSPACE, SHIPBOARD, GROUND VEHICLES AND ASSOCIATED EQUIPMENT
    MIL F 5372 : D FUSE, CURRENT LIMITER TYPE, AIRCRAFT
    MIL STD 461 : G REQUIREMENTS FOR THE CONTROL OF ELECTROMAGNETIC INTERFERENCE CHARACTERISTICS OF SUBSYSTEMS AND EQUIPMENT
    NAS 557 : 0 GROMMET, PLASTIC, SPLIT
    SAE ARP 1350 : 2012 PROCEDURE FOR INSTALLATION AND MOUNTING OF SINGLE HOLE MOUNT, CYLINDRICAL, ELECTRICAL CONNECTORS (FOR PRESSURE DIFFERENTIAL APPLICATIONS)
    MIL W 25038 : F WIRE, ELECTRICAL, HIGH TEMP, FIRE RESISTANT, AND FLIGHT CRITICAL, GENERAL SPECIFICATION FOR
    SAE AS 81044 : 2011 WIRE, ELECTRICAL, CROSSLINKED POLYALKENE, CROSSLINKED ALKANE-IMIDE POLYMER, OR POLYARLYENE INSULATED, COPPER OR COPPER ALLOY
    MS 24000 : F FUSE HOLDER, BLOCKTYPE 1- 2- AND 3-POLE, 1- TO 30 AMPERE AIRCRAFT
    SAE J 554 : 1987 ELECTRIC FUSES (CARTRIDGE TYPE)
    SAE AS 50881 : 2015 WIRING AEROSPACE VEHICLE
    SAE AIR 4567 : 2014 COMPOSITE ELECTRICAL CONNECTORS
    SAE ARP 1931 : 2013 GLOSSARY OF TERMS WITH SPECIFIC REFERENCE TO ELECTRICAL WIRE AND CABLE
    SAE AS 53731 : 2014 FUSE HOLDER, BLOCK TYPE, AIRCRAFT
    SAE AS 58091 : 2012 CIRCUIT BREAKERS, TRIP-FREE, AIRCRAFT, GENERAL SPECIFICATION FOR
    SAE AIR 1263 : 1972 TIN PLATED SOLDERLESS TERMINAL LUGS AND SPLICES ON NICKEL COATED HIGH TEMPERATURE WIRE
    MIL HDBK 221 : 0 FIRE PROTECTION DESIGN HANDBOOK FOR U.S. NAVY AIRCRAFT POWERED BY TURBINE ENGINES
    SAE AS 8020 : 1980 MINIMUM PERFORMANCE STANDARDS FOR ENGINE DRIVEN D.C. GENERATORS/STARTER-GENERATORS AND ASSOCIATED VOLTAGE REGULATORS
    MIL STD 705 : D MOBILE ELECTRIC POWER SYSTEMS
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective